Questions & Answers for: dyson vacuum protect mode

...vacuum. Small consolation, but the problem should lessen as the brush wears. Meanwhile, if all else fails, switch the brush off (hard floors mode) while vacuuming the problem carpet(s). I've had the ...

...mode on the front plate where you would normally put your foot, it would have to be repaired officially by a repairer. Replacing a protective drive belt can only be done by Dyson repairers or those ...

dyson plastic be very carefull pull this out.. now the long and thin pcb board that is hidden is what we need there is a tiny transistor,,, we need to remove this carefully..once removed,, we solder a

...protect itself. So......I simply attached a domestic DC multi adapter to the terminals on the battery that are marked + and - (the 2 outside terminals on a DC16 Dyson battery). Switched on the DC ...

...mode it does not seem to pick-up hair from the carpet. Hi there,I'm sorry to hear you're having difficulties with your DC14. The knob you're describing is the brush control, which turns ...

...Dyson. It's normal for the casing of the vacuum to become warm in use, especially if you're running your DC44 on Boost mode. The battery and motor are located below and above the handgrip, to ensure ...