...dcp-7020 fail to warm - how do i reset if i turned off and on already and waited 10 minutes Will need new fuser assy, wont reset if fault still exists, reset in menu *, 2, 8, 6, 4 super fast, machine ...
7020 printer "fuser error" Brother 7020 Printer won't print. Says, "fuser error. Turn machine off for 10 mins." The fuser has failed and needs to be replaced. If it is still under warranty Brother may
Question about DCP-7020 All-In-One Laser Printer
DCP 7020 Brothers laser printer paper jam & back cover open fault The printer feeds paper and then stops with the paper 1/3 the way into the fuser. A fault "back cover open" appears. To clear you ...
Question about DCP-7020 All-In-One Laser Printer
...dcp-7020 fuser unable to warm - as I reset the printer it just goes back to this error code how can i reset the printer to work? you need a new fuser. Not easy to install for most people I think I ...
Question about DCP-7020 All-In-One Laser Printer
I'm getting a black line down each document I scan. How do I get rid of it? Cartridge or Fuser replacement.
...DCP 7020 Thanks Check the print document to see if the ink rub of easily,if so this mean the fuser cartridge need to be change.Turn off the printer and wait until it is cool before changing the fuser ...
Question about DCP-7020 All-In-One Laser Printer
Where is the fuser located on the brothers dcp 7020 Just below the slot where the paper exits into the catch tray. It may feel a little warm in the fuser area. Thanks
Question about DCP-7020 Laser Multifunction Printer - Monochrome - Plain Paper Print - Desktop Copier/Printer/Scanner - 20 ppm Mono Print - 2400 x 600 dpi Print - 20 cpm Mono Copy LCD - 600 dpi Optical Scan - 250 sheets Input - USB
4 wide horizontal blurry lines in printed document Either sensitive drum of the tonner is damaged or the high temperature fuser roller damaged. Check and replace.
Question about DCP-7020 All-In-One Laser Printer
...dcp-7020 fail to warm - how do i reset if i turned off . A reset is pointless. When a fuser does not warm up it is usually a failure of the lamp or the thermistor. Its better just to fit a new
Question about DCP-7020 All-In-One Laser Printer
...DCP-7020 inner chute in order to replace the Fuser unit? I was able to remove the rear cover and the rear chute cover but had difficulty removing the inner chute in order to replace the Brother ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions