...Check the Head Maintenance Clutch wiring. 3. Disconnect the Wave Amp signal cable from the left side of the Electronics Module. If the error code changes, replace the Wave Amp. 4. Replace the head ...
...check shows 2 faults detected 1. 16500 P0116 035 sender for Coolant temperature. G62, implausible signal. 2.Motronic Engine control module (ECM) power supply relay- J271- electrical malfunction in ...
...you tried plugging the cable directly into your set to see if the set's built-in NTSC/analog cable tuner can receive any signal? This could help rule in/out connectivity issues or 6200 stb
...signal, it can be easily lost if the wiring is not done correctly. If there is a communication error fault CH05 will appear within 5 mins of powering up the system. Testing • Check Outdoor and Indoor ...
...signal, it can be easily lost if the wiring is not done correctly. If there is a communication error fault CH05 will appear within 5 mins of powering up the system. Testing • Check Outdoor and Indoor ...
...signal during engine rotation Power loss light: On Limp-in mode: Logic module will guess at injector timing Possible Causes: Bad connection or wiring - Check the wiring and connections between the ...
signal Power loss light: Off Limp-in mode: None Possible CausesBad connector or wiring - Check the connector at the sensor and on the wiring harness near the fuel rail
Question about 1993 C1500
...check engine light will stay one constantly. To restart code gathering turn the ignition key to the "off" position, wait three minutes and turn the ignition key back "on" again without starting the ...
Question about 1993 C1500
...if the signal from the by-pass valve is too high. The fault is diagnosed by the engine control module (ECM) when the ignition is on. Check for short-circuit to supply voltage in the signal
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions