automatic transmission problem my problem is with the automatic transmission, when the gear changes to second, the gear drags and will not change, to third, so i use the manual gear to change to third
...from the shifter on top right, so itll pull the gears when you if in and out on to or back and forth..look and see if the cable has too much slack..that hooks up to the
...automatic transmission slips gears? hello. Here are some of the transmission slipping signs you should be looking for: A delay of more than a second in shifting from the neutral to drive or reverse ...
...automatic transmission, but now it have manual transmission. After changeing transmission it gave out CEL 19 error. Another problem is that after changeing transmission, when car is cold the RPM is ...
automatic transmission can shift into overdrive mode after a certain speed is reached (usually 70+ km/h [43+ mph] depending on the load). When it is off, the automatic transmission shifting is limited
...Automatic transmission problem,click the link below:----Overdrive light in the dash blinks? http://repairhelpcenter.blogspot.com/2012/01/overdrive-light-in-dash-blinks.html--------- Automatic ...
Question about Transmission & Drivetrain for Honda Accord 4 Door
1993 honda accord wort move in any gear If it is a manual with a clutch, your clutch disk is probably too thin or "burnt". If it is an automatic, you might be out of automatic transmission fluid.
Question about 1997 Passport
...Automatic transmission will not go into high gear? http://howtobyme.blogspot.com/2011/11/automatic-transmission-will-not-go-into.html--------Manual transmission very hard to shift from one gear to ...
...Automatic transmission will not go into reverse? http://technoanswers.blogspot.in/2012/02/dodge-automatic-transmission-will-not.html ----------- Dodge manual transmission will not go in reverse gear? ...
Question about 2008 Accord
...Automatic transmission be Flat Towed behind a motor home? no the drive wheels will operated the automatic transmission which will have no pump operation to push oil through the bearings and gears ...
Usually answered in minutes!
2,998 Questions
2,681 Questions
1,631 Questions
1,636 Questions
1,570 Questions