Error code 0053 9804 appears each time the phone is turned on. What does this code mean and how do I rectify the problem? Thaqnks

How To Unlock Nokia X2
1.Get Your Unlock Code From Cell Phone Unlocker
2. Turn your phone on without a SIM Card
3. Compose #PW+CODE+1# ("CODE" is the unlock code we sent you)
(if locked from Fido/Roger Canada, please compose#PW+CODE+7#)

The letter P appear after press 3 times quickly the button star ( * )
The letter W appear after press 4 times quickly the button star ( * )
The letter + appear after press 2 times quickly the button star ( * )

4. The phone will show "SIM Restriction Off" This means you've unlocked your phone!

Read more: http://cellphoneforums.net/nokia/t342488-unlock-nokia-x2-easy-method-cellphoneunlocker-com.html#ixzz2UjsaZ3ps

Make sure none of the buttons are stuck down. If all buttons seem normal, and you're sure the battery is in right, and charged, return it for repair/replacement.

I think you probably mean 5E. This means that there is a water drain error. To clear it, turn the POWER SW OFF and back ON.
The code UE means a load unbalance and must be manually rectified by separating the clothing. To clear the error code, use the procedure outlined above.

Hi

Error code sc 547 means "Zero cross signal malfunction". This error appears due to a faulty power supply. This error code may also appear if the input board is defective or the BIC Unit is defective. Turn off the printer and unplug the printer for 30-40 minutes and check if the error still appears. If you see he error still appearing then try and rest it using the following reset method--
To reset the SC code by entering SP5810 and select 1.
Now hold down the photo mode key and the # key at the same time for at least 3 second.
Then turn the machine off and on again.
If the same issue still appears, you'll need to check and replace the Power supply or the Input (IOCC) boardt.

Hope it helps...

Hi just read your posting.Now error code 105 is called COMMS. ERROR TIME-OUT.This means the display module has detected an error in the communications between the display module and the motor controller.There are 3 reasons why this error code appears, the 1st is a faulty display module, the 2nd is a faulty motor controller and the 3rd is a faulty rotor sensor.The way this fault is tracked down is to 1st change the display module and if that does not rectify the fault then change the motor controller and if the fault is still present then change the rotor sensor.Sorry for the bad news on this fault and unfortunately you need the components to find the fault.I have double checked to see if there is a way to check the components easily and I have not been able to find one.Please reply on how you would like to proceed and I can help you as much as I can.

Hi just read your posting.Error Code 130 means your fault is called Single Rotor Position Sensor Error.This component is attached to your motor which is underneath your machine.What concerns me is your machine is leaking.Did the Error Code appear the same time your machine started leaking?The reason I am asking this is because the water could have damaged the rotor sensor.Is the water leaking underneath the machine?Please reply with additional information and I can help you rectify this fault.

#pw+138144454613345+1#
#pw+404347723205042+7#

> remove your sim and type the code 1 above then if code error try code 7... you only have 5 tries if code error still appears it means you need to unlock it by cable...
> to type "p", "w" and "+" try to type * several times...

Sorry for this but is only the service provider that can rectify the promblem. The sim card will be replace and your phone will come to life again. Thanks

take the phone to a mobile service center and have them reflash the keypad flash file back into the phone.