Hi. I am looking for a Part #486945 thermostat for Thermador PRDS486GLUS Dual Fuel Range. Thermador says it is NLA and the new part # 622568 doesn't support self clean. Is there anyone witht a #486945 one available?

Thermador are top of the range appliances and they don't expect you to repair them yourself, you call for a service engineer. Service manuals are hard to come by. There is a service manual for a wall oven and the control panel may be similar. They look to have mounting clips. The buttons are proximity detectors, so not conductive.

https://www.google.com/search?q=thermador+cet366fs+cooktop+service+manual+pdf

They are made by Whirlpool so this might help. Wherever you got the board from should supply the instructions on the same way that Repair Clinic do.

..

Use a manometer to insure lp gas pressure is correct. The regulator for the stove may need adjusting. The air mixture adjustment may not be correct for PL as well.

If you remove the knob, you will see the very center of the male part the know attaches to has a small flat head screw in the middle of it. Buy turning this screw in and out, you are micro adjusting the temp when the oven cycles on and off. Its best to have a digital thermometer set up within the oven so you can see exactly when the oven cycles on and off. It's going to fluctuate about 20-30 degrees. So set your oven to 350, let it turn on and watch carefully when the red light shuts off it should be between within 30 degrees from where you set it, up or down. If its too low,turn in( could be out, I forgot) the screw in the center of that know with a mini flat head screw driver. If you turn it and the light goes back on, you turned it up. If it does not go on in an quarter turn, you went lower. Once your digital thermometer matches up closely whith what your oven says, your good. 25 degrees isn't much to be gentile whith turning that middle screw, you could miss your mark and be off even more very easealy.

I really need to have a bit more information so I can give you a best answer. Please give me the model number of your appliance. Thank you, I did find on the net that someone on Ebay does have your part numbers, but did not go there to see if it is new or not.

Hi,
Here is a tip that I wrote that will help figure out why the burner spark keepson clicking...

Gas Range Repair Burners Keep on Clicking
heatman101

Hello I do have a brand new Bosch thermostat for this stove. Please contact me @415-424-1264

We are Thermador factory authorized service and parts suppliers. Just contact us at:

http://www.fixya.com/repair/d499389-accurate_appliance_repair_service
and we can get your ignitor and light switch out to you asap.

We look forward to working you. Thanks, Ella

Did you get an answer on this? Have the same problem and the house call starts at about $100

foxparts.com

I am looking for Thermador part # 414-564 and Bosch part # AP2831995. Anyone ???