Zanussi washer iz 12 error e10 - Zanussi IZ12 Front Load Washer

9 possible things to check per the web page below:

https://www.support.emea.zanussi.com/en-uk/Laundry/01_Washing_Machine/The_washing_machine_is_displaying_E10_C1

Have a look at the beginning of the tread, and it will become obvious that it is left or right hand.

first dry ok second dry seems too hot then errors

Is it a washer-dryer? E10 relates to a fault with the inlet valve.....usually the valve itself going open circuit.

E20 and E10

You should not need to remove anything to check and clean pump filter.
Open the filter door at the bottom right front of washer, there you will see the pump filter cover, unscrew the filter anti-clockwise, and remove the filter, and clean same.
With the filter out, you will see the filter housing, which is fastened directly on to the pump, have a good look inside the housing, and see if anything is stuck in there.
Refit filter, and test.
Please rate my fixya solution.
Thanks.

E20 code on Zanussi washer dryer ZWD1471
washing machine working but dryer is not .

Any advice please

I've just spent an hour taking mine to bits. On the back there are 2 x 9mm silver nuts at the bottom, below the star head screws you removed to get the top off. Then there are two more sneaky ones at the bottom of each side panel, just next to the gap about half way along on both sides., with a plastic cover hiding them from view. Make sure you release the mains cable holder from the top of the back by pressing the plastic clips down, then the whole shebang should slide off easily.

Regards. Paul C

e10 indicates a problem with water supply

I had this problem, the washer/dryer stopped working while in the drying cycle and displayed e10 message. It was caused by a faulty three-way inlet valve. The solenoid controlling flow to dryer condenser proved to be open circuit. Pulled washer out from under counter top, unplugged, removed top cover, tested solenoid circuits with ohm meter and found one solenoid was faulty. The filter going into the unit was clear. Replaced whole three way component with one ordered on Internet and all now works fine. Noticed that during drying cycle, water to condenser is constantly being switched on and off, explaining why the green condenser solenoid is the one that wears out first.