A code appears on my Dacor oven/stove that reads FO, what does it mean?

Page 9-48 in technical manual excerpts at the link below:

http://www.uncleharrywizard.com/nephewclub/WizardRange/dacor/dacor-wall-oven.pdf


http://www.uncleharrywizard.com/nephewclub/WizardRange/dacor/dacor-wall-oven.pdf


It says to call for service (by a technician). (I am only reading it from the document - I am not a technician.)

It says to replace glass/touchpad assembly.
It says wrong or unrecognized diode configuration.

You have a failed touchpad... Dacor Range Stove Oven Touchpad 62301B

http://products.geappliances.com/appliance/gea-support-search-content?contentId=16238

http://www.appliancepartspros.com/repair-help/dacor-fault-codes.html

I showed you what it means before. Did you follow the links?
This code usually means that there is a problem with the keypanel. Many times, it means the keypanel needs to be replaced http://products.geappliances.com/appliance/gea-support-search-content?contentId=16238

F0 Function key stuck Replace touch pad or if touch pad is part of the clock, replace the clock (ERC). http://www.appliancepartspros.com/repair-help/dacor-fault-codes.html

Hello. The error means there is a shorted key on the keypad. The part number you will need is 701044-02, called "membrane panel assembly, black". The main board, if needed, is 101991, called LED display module. Hope I helped you!

F0 means: Clock pushbutton is stuck in a depressed position. Check clock buttons. You might need a new touch pad.

Dacor range repair in orange county, ca
appliance repair orange county, ca

Hi.
Probably needs new hinges fitting.

I would call the store you bought it from or dacor as it is under factory warranty...

The code is telling you that the oven has sensed a fault in the coling fan circuit of the upper oven. Dacor has had a few problems with the cooling fans in these new ovens since theyve been out, so most likely you will have a bad fan motor. If that is the case, be prepared to have the repair person have to pull the oven out of the wall to get to it and change it. If its a realy board problem (less likely) than that can be changed from the front. Call up Dacor and find an authorized servicer in your area since it will still be under warranty. Good Luck!