May i know how many cu ft is this type of ref? (CSD2610KRW0

This is the information I could find.

Refrigerator Type Side-by-Side Total Capacity Cu. Ft. 21.7 Cu. Ft. Refrigerator Capacity Cu. Ft. 14.40 Cu. Ft. Freezer Capacity Cu. Ft. 7.30 Cu. Ft. Energy Star® Qualified Yes
for more information try this link.
Whirlpool Appliances for the Home Kitchen and Laundry Room

Bob

Did u follow the unpacking and installation instructions??
Are the sides,bottom,and back of refrigerator clear of all obsticals?
Did u remove the plastic from the ac cord prongs?

STOP PAYING FOR EXPENSIVE WATER FILTERS FOR YOUR REF. DO THIS____
http://www.fixya.com/support/r9962087-stop_paying_high_price_refrigerator
Thanks for using fixya
Leo Ponder
imufo2
Please VOTE FOR ME IF THIS WAS HELPFUL

The door switch is bad, replace yourself easily. meanwhile unscrew bulb.

ok let me help the model # RTT ( 19 )00 D LOOKS LIKE A 19 CU FT TOP MOUNT MAYTA REF . I HOPE THIS HELPED mm . majic **** .. ( most model # will tell the cu size unless kenmore . thanks for using fix ya mm feed back pls ..

19.636 US gallons

21" X 27" X 8" = 4,536 Cubic Inches or 2.625 Cubic Gallons

Which means 1 CU FT = 7.481 Gallons X 2.625 CU FT = 19.636 Gallons

lok for two screws under the edge remove them and with a putty knife or a plastic type wedge it will move up and off . hope this helped . ****

. Cut everything off for a few minutes then turn it back on and listen for a click from the compressor relay as the compressor tries to start.
Is the compressor motor running.If no check starter/overload relay.
Check to see if the condenser fan at the back underneath near the compressor is running. If no check fan.

Are the condenser coils near there warm or room temp. should be warm


How to check stuff>
http://www.acmehowto.com/howto/appliance/refrigerator/refrigerator.php

Simple! Refrigerent leak only results in poor cooling. Check your thermostate also to make double sure of the cause.

look on the rating plate and it will say how many watts. however the power taken on start up is considerably higher than when running so allow at least 50% excess