My red will not converge on my philips 52" HDTV what do I do

The tv have a problems known as a convergence problems,it dead.The tv have colors lines R,G,B mis alignment,have colors shadows pictures or 3D pictures look alike.The tv convergence board have dead 2 STK convergence ICS and some or all it resistors are dead too.These parts on the tv convergence board,must be replaced to solved the tv picture convergence problems.The shop,will cost u like $300-350 for parts and labors.

This is caused by convergence. One of the convergence ICs (integrated circuits) is temperature sensitive. The parts will need to be changed. See the tip on convergence on this website.

If the convergence option is still in the on screen menu its usually related to resistors on the convergence power supply board

Get a convergence kit from www.TvRepairKits.com

This is a common problem. Your convergence has gone out.

Common symptoms are...

1) 3D Video
2) Warped Video
3) Convergence menu does not adjust the red or blue correctly.

Go here for a solution...

http://www.fixya.com/support/r2861627-updated_convergence_problems_amp

The convergance board or faulty capacitor will have to be replaced.

Check to see if you can adjust the convergence. If you can't adjust the red and blue in all directions you need to replace the convergence chips and resistors. If you not sure how to check the convergence goto the site www.TvRepairKits.com and goto the Tips section. 

Yfour tv has a convergence board problem. Two convergence IC's are need to be replaced.

You could have a bad red tube or the socket on the tube may be bad; completely different from convergence

Hello Anthony14,

 

This is an indication the the red convergence amplifier has goone bad you will need to replace the convergence correction modules. Now before replacing these you may want to make sure that the bias resistors and the zener diodes are ok. The convergence ICs are part number STK329-110 or STK329-150.

 

I would suggest that you get a schematic and equipment to make the needed tests, or take the set to a shop to replace the bad components.

 

I hope this helps,

 

Thank you,

 

Shuttle83