If i purchase 2 locks with 2 remotes, will the remotes work interchangeablely with the locks? I don't want to have to carry two remotes one for the back door and one for the front door. Thanks.

either buy a set of locks that are keyed alike a few places carry bulk locks --or buy locks that can be keyed to what ever key you want call a locksmith and ask for places to buy bulk verses interchangeable tumbler locks

I don't know from which country you are? But remote control of almost every TV is available in electronics spare part market. Just check it in your country. All that you have to do is carry your old remote control with you while purchasing a new one. It is better to tell them the make & model number of the TV.

sonsunny

Ford can cut a key with the vin#. As far as the fob, dealerships don't carry them any longer. If you can find one on eBay the dealership can reprogram it but most are too lazy and won't bother. Google "replacement key fobs", there are a few companies that sell
Replacements and can program them for you. Pep boys and auto zone also carry replacements but I'm not sure about the programing. Good luck.

The 2 Key fob part, is to get a remote start that also has the RKE ( Remote Keyless Entry ) function. The the RMST / RKE system is installed, the RMST fob would be able to operate the door locks ( you can put the factory RKE fobs in the drawer )

the PATS ( Passive AntiTheft System ) part is to get a PATS bypass module for the remote start. The remote start that you purchase needs to be able to activate this prior to starting the truck ( usually pulse / signal outputs, most mfgr of RMST have these ).

There are a few PATS bypass modules, I have only used the Ford branded one ( which I think is also made by CodeAlarm, not 100% sure ).

Avital and viper remotes even though they look the same, they operate at different freqs. Im a retired alarm installer i could never get them to interchange.

try changing the batteries in the remote.....

I will gladly give you mine from a CH300 for free. I figure that the remotes should all work interchangably. I just need to get the priority postage costcovered. If you want to do it, contact [email protected].

don,t know what your remote carries,sounds like your are putting the wrong batt. in it. most carry AA or AAA

Synchronization
When
System malfunction. Remote control added or replaced.
How
Access alarm system control module located under driver's side lower fascia Fig. 2 . Set memory switch to SET position. Press remote control lock or unlock button. Set memory switch to OFF position. Confirm synchronization has been successful by locking and unlocking vehicle. Repeat procedure for second remote control. Synchronization can also be carried out using diagnostic equipment.
NOTE: A maximum of 2 remote controls can be programmed. NOTE: If remote control fails, system can be deactivated as detailed in the owner's handbook. Fig. 2

Hi! Its your lucky day! I have programming instructions right here! Under your steering column u will find ur DLC (Data Link Connecter) Its the data port that dealers and garages use to hook up to their computer. You will need a wire (jumper wire) that is thick enuff to carry a low voltage. And ground wire to bare piece of metal. ok here are the instructions MAKE SURE IGNTION IS SWITCHED OFF!
1) Jump DLC terminal 1 and ground.
2) Within 10 sec.. switch ignintion to ACC position and then back to OFF 3 times.
3) Doors should lock and unlock to confirm registration mode.
4) Press and release remote transmitter LOCK button
5) Within 10 sec Press remote transmitter LOCK button twice. Doors should lock and unlcok to confirm registration. If registering 2 remotes within 1 minute carry out button procedure for additional transmitters. Doors should lock and unlock to confirm registration
NOTE: to exit programming mode: switch ignition to ON. Also a MAXIMUM of 2 transmitters can be programmed at a time.