20 Most Recent 1999 Ford F150 Regular Cab Questions & Answers

notify manufacturer or distributor where bought for installation instructions have product model number and vehicle information available

1999 Ford F150... | Answered on Jul 17, 2020

When it will not start with the key, is this a crank no start issue ?

If you turn the key from off to run ( do not start ) does the theft light on the cluster go out ?

If not, try a different key. I am working from an assumption that the PATS key is not registering with the HEC for some reason, this is why the try another key. The remote start has a PATS bypass

Please post back with the answers to the questions, and the results of the 2nd key testing

1999 Ford F150... | Answered on Jun 12, 2020

No fog lightf but the bubs are new where is the fuse at on a 99 ford f150

1999 Ford F150... | Answered on Apr 07, 2020

what color is the fluid -bright red or brown ??? if brown change the filter & oil-if it dont work then the clutch packs or servo needs replacing

1999 Ford F150... | Answered on Dec 30, 2019

This usually means there is a transmission related fault. There is probably a error code stored, and your transmission may be in limp mode; usually 2nd gear only. I don't know if Autozone can read trans codes. This may be a dealer only repair. Have you checked your transmission fluid?

1999 Ford F150... | Answered on Jul 06, 2018

Important: Thoroughly wash all contaminants from around the electric hydraulic control unit (EHCU). The area around the EHCU MUST be free from loose dirt to prevent contamination of disassembled ABS components.
Disconnect the three electrical harness connectors from the electronic brake control module (EBCM).
Important: Make sure that brake lines are tagged and kept in order for proper reassembly.
Disconnect the 5 brake lines from the brake pressure modulator valve (BPMV). When looking at the brake pipe port face of the BPMV, the ports are assigned as follows:
Upper Left--Left Front Output.
Upper Middle -- Right Front Output.
Upper Right--Rear Output.
Lower Left--Master Cylinder Secondary/Front Input.
Lower Right--Master Cylinder Primary/Front Input.

Thanks. Keep updated for any more query. You can rate this solution and show your appreciation.

1999 Ford F150... | Answered on May 07, 2018

Check starter circuit, relay , starter

1999 Ford F150... | Answered on Mar 01, 2018

Any flashing lights on the overdrive button. Sounds like a messed up torque converter or a computer command to stay locked up randomly. It's just a clutch that uses fluid, but most now have a electrical controlled magnetic clutch to lock them up. If they are told (wrongly by the computer) they won't let go and will stall the motor, cause harsh shifts, etc. Diesels just won't stop with the power they make. Scan for codes.

1999 Ford F150... | Answered on Feb 04, 2018

To reset some v10 Ford's, you turn on the key (not motor) and push down the gas pedal 3-4 times to the floor and all the way up. Let's computer reset 100% on and 100% off. Dodges same.

1999 Ford F150... | Answered on Feb 03, 2018

Check the connections for power with a test light. If your getting power to the pump and it doesn't work then it is bad (new or not)

1999 Ford F150... | Answered on Feb 03, 2018

Needs a new multifunction switch on the column..

1999 Ford F150... | Answered on Jan 23, 2018

Flush torque converter and tranny flush. If you suspect that's the noise. Pump transmission

1999 Ford F150... | Answered on Jan 03, 2018

Most 98-99 have wind shield leaks that allowed rain to trickle in to the cpu wiring harness under dash. it will have to be cleaned or replaced

1999 Ford F150... | Answered on Dec 27, 2017

on the upper control arm bolts on the nut side there are different off set washers you use to change caster and camber.

1999 Ford F150... | Answered on Dec 01, 2017

Under the hood on left fender will long black box remover cover relay is the first one closest to fender and front in box.

1999 Ford F150... | Answered on Oct 17, 2017

problem torque converter clutch servo/ solenoid
check wiring and connections

1999 Ford F150... | Answered on Oct 13, 2017

It's ******* to put an old engine into a newer vehicle. You can do it the other way around, but not this way. Chances are it won't have places for all the sensors.

1999 Ford F150... | Answered on Sep 22, 2017

Not finding what you are looking for?
1999 Ford F150 Regular Cab Logo

1,120 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2004 Ford F150
2004 Ford F150

2,635 Questions

1990 Ford F150
1990 Ford F150

1,212 Questions

2005 Ford F-150
2005 Ford F-150

1,294 Questions

2006 Ford F-150
2006 Ford F-150

1,035 Questions

Top Ford Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

F-150 Ford

  • F-150 Ford

Most Popular Question

no drive gear reverse changed filter

  • Cars & Trucks