Owner manual need owner manual RCA model p52936

If you wish to get some details; check the site linked here. Pull up older posts. Surf the site with patience.
http://electro-medical.blogspot.com/
http://electronicshelponline.blogspot.com/

Are you needing a owner's manual as stated or a troubleshooting manual? A troubleshooting manual can be found here: http://www.manualslib.com/manual/138985/Rca-L26wd12.html

An owner's manual can be found here: http://www.umlib.com/brand/RCA/category/TV/model/L26WD12 or here: http://www.retrevo.com/support/RCA-L26WD12-TVs-manual/id/404ag703/t/2/

You can find module replacements here: http://www.shopjimmy.com/rca/l26wd12/

Hello
The user manual of RCA P52937 has not been published yet. But manual of P52936 is with me. I don't exactly remember from where I downloaded it. If you are interested in, send ma a mai, of send your email address to me by Fixya. I'll send a copy of it to you by return mail. Ok

Hello, your post shows that you need an owners manual for an 208 RCA TV, I suppose t's a type O and that you mean a 2008 RCA TV. You can download on PDF file almost any owners manual from the RCA website(rca.com) just click under support and provide the correct model number.

Try www.partstore.com, they have a pretty good rep for parts.
When you get on site you will have to give make, model and possible part number.
Just follow instructions..

set it up

IF THIS IS A PROJECTION TV ,,THE CENTER LAMP IS ACUALLY THE GREEN PICTURE TUBE-ANY LOCAL TV SERVICE COMPANY WOULD LOVE TO SELL YOU A GOOD USED PART- ..RCA IS NO LONGER --GO TO THE" THOMSON ELECTRONICS" WEBSITE FOR CUSTOMER SERVICE,,GOOD LUCK!!!!

Hi,

You will find the owner's manual in the link below.

P52936 Owner's Manual

The P52926 uses the PTK195 series chassis. The middle "rear projector" is actually the Green Picture Tube. If the red and blue tubes are working then all major components of the set are fine. The only things I can think of that would stop the green tube are cracked solder joints on the green picture tube socket PC board or an open high value (100k - 120k ohm) resistor on that board. If you do not have experience testing and replacing small parts or resoldering boards in a projection set then have a qualified tech handle it for you.