Can not program to my tv or sat or pinneer eqp.

Look for a button that says input or HDMI. That should scroll through the inputs available. Make sure the SAT receiver is on when you do this so the TV has a signal and may skip inputs with no signal.

You best bet really is to locate an original and not a universal remote for the set

the sat and cable boxes are like DIY items , just use a known set top box like dreambox e.t.c. ,i have a problem with my Logitech remote and pace HD sat receiver,evrey 2 -3 the sat receiver changes remote codes :) and its very annoing, but ill switch to a LED tv with integrated sat so for know acceptable i have a tip for you regarding receiver -change mylar and ceramic caps to film ones

You do not need to program the TV for SAT because your signal comes directly from the SAT, you are only using your TV as a monitor, not a tuner. Connect your SAT via standard rca, component, or hdmi cable and change the input on your TV to the same input that you have connected your SAT to. If you connect via coax cable then set your TV to channel 3 or 4, ALWAYS using your SAT remote to change channels for both options.

Hi, You will need a second Sat decoder or a A/V wireless sender but with this second option you will have to listen to the same channel on both tv.
Best is to get an other decoder.

Good evening!

You will need to program your dish remote to your tv, find the 3 digit code for your tv and on your dish remote press the TV button till all lights light up at the top of the rem, then enter the 3 digit tv code and then press pound. this will now programm that rem to your tv. be sure to press the SAT button to put back into SAT mode to operate your Dish programming.

To program your URC-3021 remote control to operate your TV, the remote has a code search function.

To search for a code for your TV:

1. On the remote control, press TV once.
2. Press and hold SET until the LED blinks twice, then release SET.
3. Enter 9 - 9 - 1.The LED will blink twice.
4. Aim the remote control at the the TV and slowly alternate between pressing POWER and TV. Stop when the TV turns off.
5. To lock in the code, press and hold SET until the LED blinks twice, then release SET.

Repeat the process with the CBL/SAT button to program for your sat box.

Hope that helps.

Most TV has Audio Out RCA jack at rear and it gives same TV Sound as coming from its speakers.
Hook audio wire red white RCA pins at TV Out and plug these pins to TV/SAT input of receiver. Select TV/SAT input in receiver to get TV program sound coming out from TV.
Hope that info will help you.

i need codes for philips remote sru 3004 wm

tnx for the irda:)