I dont know how to set it up. I put the green cord in the computer..but theres one black cord and i dont know what to do with it.

Hi,

Here is a tip that will help you with changing your dryer plug.

Dryer Cord and Wiring Dryer 3 Wire or 4 Wire

heatman101

Sorry,there is no "orange,black and green cords" on Logitech x-530 computer Speakers. Every RCA has it`s own color (yellow,black,white,red).It shouldn`t be hard to plug them in.

Hi,
If you are referring to the green light on the system tower and is blinking the problem could be the system is in stand by mode.

Turn off the computer by pressing on the power button on the system tower for 10 seconds.

Disconnect the black power cord at the back of the system tower and then again press the power button on the tower for 10 seconds. There would be no activity on the tower when you do this.

Reconnect the power cord and then power on the computer to see if the issue is resolved.


Thanks for using Fixya
Proton

Ridged Black is +ve Flat Black is -ve Green is Neutral/Earth

white and black are power green is ground the ground should be marked on the plug the black and white does not matter as long as the are on the power terminals they are across from each other the ground is by itself at bottom of plug W B




G

OYOU CAN MOUNT IT WITH THE OTHER GREEN CORD IF IT WILL REACH,OR USE A SELF TAPING SCREW AND MOUNT IT TO THE METAL CABINET,IT'S JUST AN EXTRA GROUND WIRE-MIKE

Your speaker system is designed for the 5.1 surround. *********** board manual shows you which wire goes to where. 

this is the rule of thumb,white always goes on the middle terminal ,the 2 outside terminal wires it does not matter which side they are on,if you can see the red and black wire on the terminal block then match them up,the green wire gets mounted to the cabinet,you should already have a green wire to the cabinet so remove the screw and put both wires there and your done,let me know how you do-mike

on the back of your dryer.
1.connect the white wire to the center of the junction box.

2.than take the red wire and connect it to the left side of your junction box.

3.than take the black wire and connect it to the right side of the junction box.

If you have a green wire on the cord as well. PLEASE make sure it is connected to the dryers back panel. do not leave it to hang.

Please do not forget to rate and comment about your experience today.

hi Deadking

You have to look in the back, and down where the lan are, is the 5.1 sound card, you have some inputs there, I dunno what brand of speakers you have, but commonly you have to put according with colors, green, black, orange, or if you have only 2 speakers, just put on the black or green output. turn up the volume in control panel, and see if not on mute. good luck