What is the run/rest time - Refrigerators

If you would like to run 3 and 4 separately from the rest of the system you may set them on program B or C. If you just want to run those two zones and nothing else just take the run times off the rest of the zones.

Some models have an overload sensor that if the unit gets too hot it shuts down, but one hour of rest should have reset that. You might have something jammed in the tines, could be paper or a paper clip. Examine the times for something that could foul it up.

you will need a computer rest to get it to start on your code readers they wont rest mem codes only the dealers can rest those....bmw is the same way i did the same thing . dealer zapped it in five min car runs great now

The error code means that fuser cleaning web is about to run out or has run out. The fuser cleaning web cleans off the upper fuser roller (the hot one) and it also lubractes the roller. Most of the time when it runs out it starts to ruin the upper fuser roller. The best thing to do is to have the web replaced and the counter rest. If you just rest the counter, you may end up causing my damage to the fuser unit. Good Luck

With numerous shop visits,I don't like
to even suggest anything --BUT --

I would be almost certain, that the fuel pump
is worn & binding up & the shops, as strange &
sad as it sounds,do not know how to test it

First have your power supply check, for correct voltage output. Then your motherboard. Remove all the rest of the peripherals (hard disk, cards, memory, etc). Reseat the processor and turn the PC again. If you hear a beep sound, that means your motherboard is running good. Connect the rest of the devices. If not, buy another compatible motherboard. Good luck.

well sounds like it time to check those spark plugs there is no need to keep your foot on the gas to keep running.

Training (enter) Work Outs (enter) Interval (enter) Time/Rest Time (enter) Enter 00:10:00 for time (It's a bit cumbersome but you have to scroll up and down for the numbers). Enter 00:01:00 for rest time Make sure you have enough Reps set for your run. If in doubt set it very high (40) Scroll down and select done. You will have to scroll to this same page every time you want to use the 10's and 1's. Just cycle through the page with out changing anything and select done, you're ready to go!

Training (enter) Work Outs (enter) Interval (enter) Time/Rest Time (enter) Enter 00:10:00 for time Enter 00:01:00 for rest time Make sure you have enough Reps set for your run. If in doubt set it very high (40) Scroll down and select done. You will have to scroll to this same page every time you want to use the 10's and 1's. Just cycle through the page with out changing anything and select done, you're ready to go!