How to program remote for elite sl-3000 - Elite Sl 3000 Ul Sliding Gate Operator

General answers only, sorry. Look for loose or corroded connections, especially where wire nuts were used. Reprogram the remote receiver. Disconnect power to the receiver for a short time. Reconnect and reprogram. I hopes that any of this helps. I have operators to the much like witch craft, a black science!

Hi Mary, do you have more than one remote for the gate? Your remote needs to be paired with the gate receiver. Normally you need to push a certain button on the control panel to enable learning mode then you press the remote button you want to use. You will have to follow this learning process for your device. Please keep in mind that just any remote will not work with your gate, it needs to be on the same frequency and use the same modulation mode.
Hope this helps.

Hmm, this sounds spooky! ;-) No, seems you have radio interference from another source, you will have to see a specialist to work on another code or frequency.

Hope this helps.

I have a eg640 and my mother in law has the same eg640 for are gate

hi,
You have to oppen the motor control pannel. There will be circuit board inside it. In the circuit board you can see a Push button switch. It is the learn switch.

After powering ON press and release immediatly this learn switch. With in 30 seconds press and hold the button you wish to use until two click heard from the control board.

If you can sent me your email id through FixYa then i will sent the picture which shows the learn switch.
OK.

http://www.amazinggates.com/v/assets/Manuals/Elite-SL_3000-manual.pdf
Hi please find above your user manual, all you need to know should be in there?

the auto close has been set or the motor has been set up in reverse and it is auto reverseing,make sure the gate is opening up all the way, if it is not just help it along and see what happens.

if you take the covor off the unit and look at the motor their is a redbotton. press that back in and tru again

the elite does not have that function, your are going to need to look for a time clock that holds open your gate...... the outside phone system or a programmable time clock that has been added to your gate...... oh this is an old post sorry. :)

The photo eye sensor is defective of is out of its correct posistion!
Hope this was of help!