Will if damage anything if you leave cart in tow mode with charger plugged in

If the charging port and plug have been replaced and the charger still does not work, there may be an issue with the charging circuit in the golf cart. Here are a few things you can check:

1. Charging fuse: Check the charging fuse to see if it's blown. If it is, replace it with a new one of the same amperage.
2. Charging relay: Check the charging relay to see if it's working properly. You can do this by using a multimeter to check the resistance across the relay contacts. If there is no resistance, the relay is bad and needs to be replaced.
3. Charging receptacle: Check the charging receptacle to make sure it's getting power. Use a voltmeter to check for voltage at the charging port.
4. Charging controller: The charging controller may be damaged if the charging port and plug were melted. Check the charging controller for signs of damage or overheating. If it's damaged, it will need to be replaced.

If none of these solutions work, it may be best to take the golf cart to a professional mechanic or dealer for further diagnosis and repair.

This might help
http://www.golfcarcatalog.com/golf-cart-blog/golf-cart-tow-run-switches/

Troubleshooting a golf cart - APLawrence.com

aplawrence.com > Miscellaneous

Mar 29, 2015 - If you need help with a golf cart, I suggest asking at Buggies Unlimited. .... Within a half hour I had everything in place, cinched down, connected and ready. ...it is still getting power to the forward and reverse other words itsworking and ... I let mybatteries completely drain and now the charger won't turn on, ...

Put Spring In Your Electric Golf Cart ' Golf Cart Talk Blog

https://www.golfcarcatalog.com/golf-cart.../put-spring-in-your-electric-g...

Mar 9, 2004 - On a car with 8-volt batteries, connect a 12-volt charger to each individual ... If you do not have a 'Regen' system, then just put the Forward/Reverse(F/R) switch into the .... speed controller stays dormant and will not permit the car tomove. ..... My other question would be did anything "fail" in the cart prior to ...

About Golf Cart Battery Chargers ' Golf Cart Talk Blog

www.golfcarcatalog.com/golf-cart-blog/about-golf-cart-battery-chargers/

Apr 1, 2012 - Tutorial on golf cart battery chargers, the basics, what goes wrong, ...BATTERIES ARE DEAD AND CHARGER WON'T COME ON ... This is usually indicated by a car that creeps when the brake is off and the car is in forward orreverse. ... a connected pair of batteries with a 12 volt, auto style battery charger.

Basic EZGO Golf Cart Problems And How To Fix

This can be one of several problems. Make sure charger works on another cart first. If it does then check total voltage of your cart, has to be at least 42 volts before charger will turn on. If you plug in the charger and it does not turn on then listen for a small click from inside the charger. That would be the relay and if it operates then your voltage is ok and you have something else wrong. If you don't hear the click then check the small gray wire at charger receptacle. It sometimes breaks just inside the receptacle, Without this sense lead, charger will never turn on. If all batteries, wiring, sense lead, fuse in the sense lead are ok, then it might be the OBC (on-board computer).

Battery charger is probably of the intelligent type containing sophisticated circuitry which is very vulnerable to being damaged or weakened by excessive heat, voltage surges and transients. Such chargers should really be used with additional surge protection.

When such a charger fails to work there is little an owner can do other than check the supply and the fuses and connectors, both on the charger and on the golf cart. If everything that can be tested is ok it is the task for an engineer to carry out repairs.

There is a switch in the plug that will keep it from engaging. You said that the charger is working. How is it that you determine this? A thumbs up would be greatly appreciated if answer is helpful for your question. THANK you and GOD BLESS

He may not have known to put it in tow mode and doesn't want to get blamed for damage to transmission towing it in wrong gear.

never leave charging all the time you want to charge it every 6 hrs of running time to let your batterys cycle down. it would be the same if you charge your cell phone everytime you make a call if you cant keep track of it get a state of charge its a volt metter like a gas gauge for the batterys if you do it my way you will get more run time and your batterys will last around 10 yrs if keep doing it your way them about a couple yrs on them

I have an EZGO powerwise 36V charger, model 28115-GO3 that was installed onboard a cart. I want to use this charger for another cart, but the charger has 3 wires out. Why 3 wires? One is +, the other -. what do I do with the third wire? The wires are red, black and yellow; two odf the wires are 10-12 gauge, the other is around 16 gauge.

You can try a reset on the printer using the # and the number 6,holding them down while plugging in the power cord at the back of the printer.if the problem again comes up try thesame with # and the number 9 buttons
see if it works,else get your printer serviced