When I press unlock nothing happens only all green light are on can someone help me please
ALL of these answers are TOTAL GUESSES! The fact of the matter is that it could be 1 of 5-15 possible things. Anywhere from a shorted sensor to a simple remote reprogram. If you want it FIXED CORRECTLY. Simply take it to whoever installed it(or a dealer near you) and they will have it, not only, taken care of. But they'll probably also explain what happened and other possible problems/glitches & corresponding remedies for the future. Bottom line...you start pressing and holding buttons without actually knowing what you're doing, or what's wrong. You could just cause more significant problems! Like locking yourself out & having to disconnect it! You bought it...enjoy the benefits of "customer service". While it still exists!
SOURCE: the battery was taken out
Put the key in the ignition turn in two clicks. Take the key out hold down the program/valet button on the remote start then hit the unlock button on the remote.
SOURCE: Viper remote stopped working!
First things first. Check the fuse that powers your alarm system. If that seems to be ok then try the next simple option. Open the hood and disconnect the negative battery cable. Then turn the ignition to the start position for approximately three minutes. This will allow for any remaining energy to dissipate from your system. Now you can reconnect the negative cable. *** Before trying your alarm *** turn the ignition on and off 3 times quickly. Make sure you don't start the vehicle. Now you can exit the vehicle and try your alarm. FYI you can always stop at a nearby Best Buy store for additional assistance. They are usually very helpful. Good luck and best regards, Rico...
SOURCE: i have a viper alarm with remote start the remote
the alarm is in valet mode .open a door press lock unlock lock on the remote and it should take it out of valet mode
SOURCE: Can you lock the viper 5301 keypad?
Yes.
Press and hold Function (f) for 12 seconds.
Press and hold Lock for 2 seconds
(The keypad will light up)
If the green light by the lock button shows keypad lock on/off (no light).
Press lock- green light comes on.
Press and hold f for 2 seconds
Command entered
Press and hold f or wait 30 seconds for it to time out and the amber light turn off.
SOURCE: How do I lock my keypad
there is a way to do it in the manual which can be found at www.viper.com/support.... i did it by mistake and now can't figure out how to turn it off
6,825 views
Usually answered in minutes!
×