How can i solve the code 0060 on my machine km-6030

Defective developing humidity sensor or poor contact insertion connector problem try to clean the connector but before doing all this first empty the Dev Unit clean it well the insert it back into the machine and start the equipment.

Hi Farid,

Error Code c7200 means : Broken internal thermistor wire • The thermistor output value is 4.5 V or more.

Because of : Poor contact in the connector terminals. Defective developing humidity sensor.Defective engine PWB.

Need to replace the defected part. please visit to the nearest service center.

Thanks

I am living in a Pakistan Village and have cyocera K-6030. I am facing an error on control pannel C3300, I would be most grateful, if I may be informed only that in which part of the machine this fault of C3300 is? it solution please. Thanks with regards. my e mail no is [email protected] and [email protected]. If some one here can show me its solution, because my e mail is also not opening. thanks. my name is ghulam muuhammad

Open the Glass and clean the opitcals. dirty mirrors and ccd. Run mode 906 after.

I’m happy to help further over the phone at https://www.6ya.com/expert/mustafa_06f84c65ab5cc745

km 6030 machine have a code on screen c7200 so how i solve it

KM-6030 or FS-6030. if it is the fs open the fron door, remove the waste bottle and replace it with a new one (they come with the toner). if it is a KM or CS 6030 that should be covered under your service plan. if you are running a segment 3 machine without a service contract you need to reevaluate your situation.

laser scanner unit and main PWB check for correct operation

Go the Kyocera web site and search for the error code. Also, you may need to enter your model. Good luck.