There is a flashing symbol- black rectangle with two white triangles one on top of the other mower stops but will restart after a few minutes. Cub Cadet LTX-1050, v twin1 Hydrostatic

flooding check for bad silinoid or bad needle and set rebuild carb

Hi Haley
Here are a few suggestions

If you have access to an electric voltmeter, with it running check voltage at the battery. The engine should charge the battery and maintain system voltage so that the electic PTO will function. The electic PTO will not pull in if system voltage is too low.

This simply means that your copier thinks it is jammed. Look for any bits of paper in the machine. If no paper is found clean any sensors that you see.

The Service Monitor meter contains a service minder function that utilizes the 4-digit LCD display. The letters "CHG" will display followed by the letters "OIL" and then followed by the meter accumulated time. "CHG"/"OIL"/TIME will alternate on the display for five(5) minutes after the meter reaches 50 hours. The display will also flash as described above for five(5) minutes every time the tractor has been started during the maintenance time interval. The interval will occur every 50 hours and will be in effect for two(2) hours ( Example: this feature will display from 50-52 hrs., 100-102 hrs., 150-152 hrs etc...). While the LCD is displaying the "CHG"/"OIL"/TIME letters, the red LED "oil symbol" will also be flashing for the entire five(5) minutes. The meter display will return to normal function automatically after the reminder maintenance time interval of two(2) hours.There is no method of manually re-setting this Service Monitor gauge.

check the bowl for dirt or try putting in some stable

loosen fuel cap as it runs. might not be venting.

you must fullflash your BB to work it again.you can use desktop manager 4.7 to flash your phone.
and here you can download firmware:http://na.blackberry.com/eng/support/downloads/download_sites.jsp

that triangle means you have activated your roaming feature on your phone......so you should contact or visit your carrier and have them deactivate it for you.

Greetings...

The red or orange cast comes from a warm light source since you have the auto white blance off...

Got to your menu and turn the auto white blance back on and then try taking the same picture under the same lighting and see if that corrects your problem...

Ed