Cub Cadet Garden - Recent Questions, Troubleshooting & Support

0helpful
1answer

Cub cadet 44 inch 20 HP kohler engine. Dies when brake released. By passed seat switch, still does same thing.

While seat occupied, the safety relay is energized and opens the seat to PTO switch and Brake switch kill circuits.

Check the operation of the safety relay.

With engine off and key in RUN position you should hear the relay click when you sit in the seat (remove your seat switch bypass and reconnect seat switch).
9/8/2021 6:28:21 PM • Cub Cadet Garden • Answered on Sep 08, 2021
0helpful
2answers

I have a 2005 50in cut cub cadet enforce zero turn right level pull back won't go in revert run very slow going forward

Service the clutch and trans. Haynes or clymer make a shop manual for ur model. Umust do monthly maintenance
9/5/2021 12:32:26 AM • Cub Cadet Garden • Answered on Sep 05, 2021
0helpful
2answers

Cub Cadet Tank.(zero turn)

Common for parking brake switch to not be depress enough. CK It.
9/1/2021 2:49:56 AM • Cub Cadet Garden • Answered on Sep 01, 2021
0helpful
2answers
0helpful
1answer

When replacing drive belt on 48" Cub Cadet Enforcer do you have to remove idler pulley?

Likely it will need to be loosened, but not necessarily removed. Make note of the position of any belt retainers and return to original position when tightened.
8/28/2021 12:07:40 PM • Cub Cadet Garden • Answered on Aug 28, 2021
0helpful
1answer

Cub cadet run on issue when hot?

Check the carburetor anti afterfire solenoid is functional. Avoid fuel with more than 10% alcohol.
8/26/2021 9:18:03 PM • Cub Cadet Garden • Answered on Aug 26, 2021
0helpful
1answer

What would cause my Cub Cadet mower Zero Turn Mower to run hot

Cooling fins are blocked.
8/22/2021 8:44:41 AM • Cub Cadet Garden • Answered on Aug 22, 2021
0helpful
2answers

2012 cub cadet LGTX 1054 motor bogs down and has very little power when electric PTO is engaged to mower deck.

Kohler SV740This is almost always a combustion issue.Check RC12YC plug gap is 0.030"Running on one cylinder? Disconnect a plug wire and start. Reconnect plug wire and disconnect opposing plug wire. Start.If only running on one cylinder and gap and spark are good then check OHV lash.If missing or poor spark on a cylinder... likely ignition module failure.If starter intermittently stalls (makes 1/2 revolution, pauses, continues), valve lash out of tolerance.Fuel - drain carburetor fuel bowl. Capture fuel and check for water.Check battery voltage while engine running. If less than 13V then charging system failure.If you want to test the PTO when on...remove both spark plugs, switch PTO on. Pull deck belt through but you may not have enough leverage on the PTO pulley, Try rotating the fan side (top) of crank by using both hands flat on the fan, push/pull clockwise. Else a 5/8 socket and bar on the clutch bolt (bottom end of crankshaft) will easily turn the crank/clutch.
8/22/2021 1:12:29 AM • Cub Cadet Garden • Answered on Aug 22, 2021
0helpful
3answers
0helpful
2answers

We have a 2166 Cub Cadet. After mowing the lawn

Could be couple of things...blockage in fuel filter....tank cap has blocked bleed hole pressurising fuel tank....magneto either coil or condensor on way out
8/22/2021 12:44:17 AM • Cub Cadet Garden • Answered on Aug 22, 2021
0helpful
1answer

Where does belt tensioner spring

go to this site and put your info in and you should find what you need

http://manuals.mtdproducts.com/mtd/Public.do?BrandCode=10051&langId=-1
8/9/2021 9:16:07 PM • Cub Cadet Op's... • Answered on Aug 09, 2021
0helpful
1answer

Need a wiring diagram for a cub cadet ltx 1040 for the solenoid

https://www.ccparts.com/cub-cadet-parts-diagrams/cub-cadet-ltx1040-tractor-2011-13wx90as009-2011-13wx90as010-2011-13wx90as056-2011-13wx90as210-2011-13wx90as256-2011-electrical-schematic/AD-4285-4650-186052
8/7/2021 6:29:28 PM • Cub Cadet Garden • Answered on Aug 07, 2021
0helpful
1answer

RZT 54 Cub Cadet Zero Turn

Check if any one of the pullies wobble. Check the position of all the pulleys. they must be in line with each other. Most probable cause is the engine or motor mounting may have degraded that makes the motor wobble. Check all rubber mounts.
8/3/2021 2:19:05 PM • Cub Cadet Garden • Answered on Aug 03, 2021
0helpful
2answers

How do I adjust the choke on cub cadet rzt-s

Generally there is a mechanical choke from the throttle linkage. The throttle may have slipped from the clamp at the carb. There will be a screw that holds it in place. Loosen this screw and move the throttle cable forward then retighten. You may have to remove the filter to see if the choke is closing at full throttle. This should help.
7/31/2021 12:20:55 PM • Cub Cadet Garden • Answered on Jul 31, 2021
0helpful
3answers

Cub cadet belt keeps coming off the deck

Link to see video of the Fix for cubcadet deck belt coming off can be viewed here: http://www.youtube.com/watch?v=Pd4nYovcnvY
7/19/2021 3:05:13 AM • Cub Cadet Garden • Answered on Jul 19, 2021
Not finding what you are looking for?
Cub Cadet Logo

3,767 questions posted

Ask a Question

Usually answered in minutes!

Top Cub Cadet Garden Experts

dannydoesita

Level 3 Expert

777 Answers

Phil Walker
Phil Walker

Level 3 Expert

610 Answers

john h

Level 3 Expert

24959 Answers

Are you a Cub Cadet Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...