What is electroklux washer code E00 - Electrolux EIFLW55HIW Front Load Washer with IQ-Touch Controls

On some Bosch models, E00 indicates that the machine is overloaded. Alternatively, the load is too heavy when wet. The machine can't safely spin the load. You may need to take this blanket to a laundry mat and use their commercial size washer.

Try running the washer when empty. If the error recurs, then the problem isn't the blanket. Instead, the motor is working too hard to spin the tub. This could indicate a problem with the motor or the pulley and hub that connect the tub to the motor.

I wish that I had better news for you.

Cindy Wells

The E00 code on your SAM4S cash register indicates a Sequence Error.

You can try an Initial Clear to reset the error:

1. Turn the power switch located on the right side of the register to the OFF position.
2. Turn the control lock to the P position.
3. Press and hold the key position where the SBTL key is located on the default keyboard layout.
4. While continuing to hold the SBTL key, turn the power switch to the ON position.
5. The message "INITIAL CLEAR OK!" prints when the initial clear is complete.

You may have to try the Initial Clear procedure a few times to clear the E00 error.

http://www.manualslib.com/manual/409085/Electrolux-Ewfls70jiw.html

I appreciate your post, Anonymous!
From what you have described your Electrolux washer is displaying an error code of MB, E33, and UI Alarm E00. I have been unable to locate those error codes. May I have your model number, please? With that information I will be able to assist you further. -Matt

Check the pump trapped there may be coin lint block pump from draining there a panel on the washer front right down near the bottom of washer were the pump located at

Perry My friend...You need a New Drain Pump. They fail quite routinely and they are the bread and butter for service guys. Once you replace it your trouble and error code will go happily away!

If you need further help, reach me via phone at https://www.6ya.com/expert/steven_b77d19396bfe2249

I recommend using a lockable enclosure.
e.g. NBP141004-E00 ( 14x10x4 Inch Universal 120 240 VAC Weatherproof Enclosure NBP141004 E00 ).

Hi William, thank you for your post!

If you are getting error code E00, it usually indicates that your washer is experiencing a generic error. One of the best ways to determine if this is a false error code is to reset the power to the appliance by either unplugging it or flipping off the breaker for about 30 seconds. If the error code

have u tried clearing the filter

Here how you "test" the system: http://www.fixya.com/support/t9576766-found_small_part While in test mode "t02", you can reset all the error codes by holding down Start until it displays E00. If you find errors in the t02 test, make sure you write them down before clearing.