Partial picture frozen

Remove the gas cap, to let some air into the gas tank.
As the gasoline has been consumed, what's left behind
is a partial vacuum, making it difficult for the fuel-injection pump
to pull gasoline from the tank. Remove the gas cap,
to equalize the air pressure. Works for me (and my 2002 Taurus).

With a DLP TV, getting a darker picture means it is time to change the bulb.

The power source to the pixels is defective.

mine has just done the same did you find out how to solve it

try adjusting your color tuners located inside tv behind speakers.

Try to finde lose connection/ cold solder joint at board attached at end of picture tube. It seems heater/ filament voltage not being supplied to picture tube after a while and picture goes to black.

sgtken,

I also purchased the same unit. Please let me know if you figure out how to get the unit back to factory settings. I checked over the unit and do not see a reset button. Thanks!

Bill
[email protected]

Bad capacitors on Hyper module = no longer available, but
can be rebuilt by PTS Corp or a qualified tech...........T.

unplug the tv before you go to work or for a couple of hours then plug it back in and let the tv warm up for 15 minutes and adjust the covergence