RAPOO h6060 led is always red

I would have to guess, that is probably not the correct remote. I feel I must inform you, trying to upgrade your firmware, from an unsavory hacker, can turn your unit into a brick(doorstop). IMO, proceed with caution.

Try an auto search with the remote, you might have already tried it :

1. press tv

2. press select and the red button simultaneously untill the LED light flashes twice

3. Then keep pressing the TV and Standby buttons one after the other (not at same time) until the tv swithches off, then press select to store the code, the LED should flash twice to confirm this.


Once you have the remote working the TV, you can get the remote blink back the TV code so you can write it down for future reference.

• Press the TV button on the Sky remote
• Hold down Select and the Red buttons together for approximately two seconds until the LED blinks twice
• Key in 9, 9, 0
• Key in 1 on the numeric keypad and count the number of times the Red LED blinks. This is the 1st digit.
• Repeat for 2 and 3
• Note: no Blink = 0 (zero)

Try an auto search with the remote, you might have already tried it :

1. press tv

2. press select and the red button simultaneously untill the LED light flashes twice

3. Then keep pressing the TV and Standby buttons one after the other (not at same time) until the tv swithches off, then press select to store the code, the LED should flash twice to confirm this.


Once you have the remote working the TV, you can get the remote blink back the TV code so you can write it down for future reference.

• Press the TV button on the Sky remote
• Hold down Select and the Red buttons together for approximately two seconds until the LED blinks twice
• Key in 9, 9, 0
• Key in 1 on the numeric keypad and count the number of times the Red LED blinks. This is the 1st digit.
• Repeat for 2 and 3
• Note: no Blink = 0 (zero)

I have this problem too now. Did you fix it? Any advice and help would be appreciated.

It could be a 64 bit issue verses 32 bit

DUDE THIS SAME THING IS HAPPENING WITH ME BUT I BOUGHT IT YESTERDAY AND TODAY NIGHT IT SHOWS RED LIGHT CONTINUOUSLY! PLISS HELLP MEE

It would sure be nice to know what item you are talking about. If you bought it 60 days ago, I would take it back and ask for a replacement.

some devices doesn't have indicator that it is already fully charged so my advise is since almost all rechargeable gadgets needs to be charged 4-8 hours depending on the power needed by the device for example a cellphone that uses 37 volts li-ion battery should be charged 3-4 hours to use it in its maximum capacity. so look how much power needed by the device and charge it at least 4 hours for the battery to be full.

the steady red light showing when in charger shows that
it is charging. the blinking red light when taken out of
charger or turned on and off means it is not fully charged.
leave it in charger till red light turns green.