Sony nwz-a826 pasiring with blueant z9

The typical setup with a Bluetooth is press whatever the main button on the device is until there is a glowing blue light (usually about 3-6 seconds). You then need to go to the Bluetooth menu on the phone (under settings). Select scan for devices. After a few seconds, you should see Blueant Z9. Select it. it will then ask for pin to pair device. It should be either 0000 or 1234. After that, you should be all done.

Yes, its available at Rs. 12,345. Please check this link:

http://in.tolmol.com/SONY%20WALKMAN%20NWZ-A826%204GB%20MP3%20PLAYER%20WITH%20VIDEO%20PLAYBAK/prices/11633651

Hope this helps..

passkey is 0000

Reset the z9 by pressing the vol -/+ and MFB all at the exact same time. make sure you click them all at once like a mouse to a computer, do not hold them. When you get a consistent rapid flash go to your phones bluetooth menu and search for devices. select the Z9 and enter the pin code 0000 if prompted.

Rylan

passkey for the Z9 is 0000

I will forward a link to a page where you can get more information about this.

http://www.kb.sony.com/selfservice/microsites/search.do?cmd=displayKC&docType=kc&externalId=C454695

Finding it impossible to get videos onto my Sony MP4 player - NWZ-A826. i fedup solving this problem kindly hellp me in this metter at earliest or take it back your product

You will need to set the Z9 into pairing mode before your iPhone will find it.

The manual for the z9 is here

With the Z9 OFF, Press and Hold the MFB for about 6 seconds. The LED will appear a solid Blue, and then will start flashing. The Z9 is now in Pairing mode and ready to be found in searches by other Bluetooth devices. Pairing mode will be active for 2 minutes.

Enter Passkey "0000" when your phone prompts you. The phone and Z9 will now Pair.

1. Delete the old Z9 pairing
2. With the Z9 OFF, Press and Hold the MFB for about 6 seconds. The LED will appear a solid Blue, and then will start flashing. The Z9 is now in Pairing mode and ready to be found in searches by other Bluetooth devices. Pairing mode will be active for 2 minutes
3. Enter Passkey "0000" when your phone prompts you. The phone and Z9 will now Pair

I hope that helped.

Pairing Procedure
This is an example only and may differ from your phone, but the process will be the same.

With the Z9 OFF, Press and Hold the MFB for about 6 seconds. The LED will appear a solid Blue, and then will start flashing. The Z9 is now in Pairing mode and ready to be found in searches by other Bluetooth devices. Pairing mode will be active for 2 minutes.

Perform a Bluetooth device discovery on your mobile phone to add a new device.

Enter Passkey "0000" when your phone prompts you. The phone and Z9 will now Pair