Sony XM-2002GTR Car Audio Amplifier Logo

Related Topics:

Question about Sony XM-2002GTR Car Audio Amplifier

2 Answers

Help A friend gave me a sony XM-2002GTR amplifier because one day he opened it up and was turning two screws on the inside and he couldnt get it back workin. What could i do to possibly fix it. Thanks!!

Posted by Danny Hines on

  • 1 more comment 
  • Danny Hines Aug 19, 2007

    it was two controls im pretty sure

  • Danny Hines Aug 19, 2007

    yeah it was two controlls, you got any helpfull ideas. Thanks

  • Danny Hines Mar 18, 2009

    it looked to be two controls

×

2 Answers

Anonymous

I also have this problem with the amp

Posted on May 24, 2008

Anonymous

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 113 Answers

Was it two screws or two controlls.

Posted on Aug 09, 2007

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Xm-2002gtr amp keeps kicking protect light on

check your amp and speakers and make sure their both hooked up 4 ohm instead of 2 ohm because if you have 1 set of voice coils on your speakers they can only be hooked up four ohm and not bridged to your amp because if you keep trying this you will lock up your speakers if the speakers are only 4 ohm than just hook them up regular to each channel on your amp if your trying to brigde four ohm speakers to your amp it will keep going into protect or worst case scenario you will fry your speakers and you can check your ohm with a ohmmeter trust me my brother owns a stereo shop
2helpful
1answer

Amp goes into protect when turned up.

that amp is only stable 2 about 4 omhs mono the powersupply shut dowm drawing t much current it supposed 2 2 fix this u need a 4omh load mono change speaker config so u get 4 omh or buy amp stable down 2 1omh can be expensive
1helpful
2answers

My amp stays in protection mode

Does it go into protect in the vehicle if you disconnect the speaker wires from the speaker terminals of the amp?


1helpful
2answers

Protection light keeps coming on

Check the wiring between the sub and the amplifier. That's seems to be the only thing left that could cause a problem. If it's shorted to ground or pinched so the conductors are shorted together, it could cause the symptoms you listed.
0helpful
2answers

Protection light

You cannot parallel two subs AND run them on the Bridge. You must have at LEAST a 4 ohm load on the bridge, and 2 4 ohm subs in parallel equals TWO OHMS. BAD!!! Move each sub to it's own channel or your amp will soon fry.
0helpful
2answers

Amp protection light

Hi again, Looks like you posted twice, in any case pls have a look at your other post @ http://www.fixya.com/support/t182326-amp_protection
0helpful
2answers

Amp shuts off when music turned up

try adding a capacitor to feed the amp. these are large in capacity (farads)and dims (about 6' x3' dia.)...what wire size are you using?
0helpful
1answer

Sony XM-2002GTR Car Audio Amplifier

I don't think it is a problem. Your amp probably has a power-saving mode being activated at low volume levels. Actually I don't know exactly what your amp is, but this is just a guess, and it could be a plausible one as long as you can get sound without using the amp. If it is so, it must have a function to deactivate the power-saving mode.
0helpful
1answer
Not finding what you are looking for?

131 views

Ask a Question

Usually answered in minutes!

Top Sony Car Audio & Video Experts

xxxxxx xxx

Level 3 Expert

5102 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Marvin
Marvin

Level 3 Expert

85242 Answers

Are you a Sony Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...