20 Most Recent Jenn-Air JFC2089HE French Door Refrigerator - Page 2 Questions & Answers

the door rollers may be freeze with ice,unplug the refrigerator for few hours till it melt, avoid to broke the door.

The drain hole is probably frozen over. When it goes into defrost mode every 10 hours or so, the evaporator heater removes the ice from the evaporator. There is a drain hole under the evaporator with a hose attached that goes down to a pan by the compressor fan where it is evaporated so as to not leak water on the floor. When it freezes over the drain, the water fills the bottom of the freezer until it comes out the door. A common fix to prevent the drain from freezing over is to take a bare copper 14 or 12 gauge wire and put a couple turns around the evaporator heater and stick the other end into the drain. This heats the wire enough to keep water from freezing b over the drain hole.

Try turning the=> 8170840 Defrost Timer clockwise slowly. It may be stuck in the defrost lobe and the timer is so weak it cannot turn to get out of defrost,. Sea Breeze

Problem seems to be solved. I unplugged it for a short time and plugged it back in. I'm guessing it needed to be re-set.

In most of this cases the ice maker cannot be repaired.Its faulty ice maker module unit.The ice maker has to be replaced.----------

If a batch of ice gets caught in the teeth during the ejection process, the ice maker module will make a constant creaking noise as it continues to try to eject the cubes. Freeing up this type of jam would eliminate the creaking noise.This is the only source of a constant creaking noise.But in this problem you will notice the ice blockage in the unit and frozen ice in the unit.But if you dont see any such thing and still there is noise then its faulty ice maker.Replace the ice maker and that will help.

You will need to replace the ice maker, the fingers are jammed in between ice making cycles, even raising the arm until it makes the complete cycle will continue to do this. Opening the door of the unit allows power to be removed from the unit and shuts it off until the door is closed again.----------------

See fig below for ice maker on your unit:--

---------To order this part click the link below:---

http://www.repairclinic.com/PartDetail/Ice-Maker-Assembly/915772

------------For part by part disassembly of icemaker click this link:---

http://www.searspartsdirect.com/partsdirect/partsdirect/showSubComp.pd?imageUrl=http://c.searspartsdirect.com/lis_png/PLDM/M0703161-00012.png

-----------------This should help.Thanks.Helpmech.

I have a Kenmore Elite Trio and the freezer was making a frog sound. I found the solution.

My model number is 596.75523400. The sound will stop when the freezer is opened. It will stop again when the freezer drawer is open and the light switch is pressed to turn off the light. The ice drawer was full but it had stopped making ice.

Here is the fix in less than 10 minutes using only a screwdriver.

• Take out the two freezer baskets
• Remove the freezer door from the two slide tracks.
• Unplug the icemaker electric connection at the back wall. Depress the clips on the side of the plug and wiggle it loose.
• There are 3 screws that attach the icemaker to the left freezer wall. Remove the lower screw and unscrew the top two about ½ way out.
• Slide the icemaker up so the slots slip over the 2 screws.
• Put the icemaker in the sink and run a bit of water on the frozen cubes until they fall out.
• Take the screwdriver and check the water inlet hose/pipe for ice that obstructs the flow of water into the ice maker.
• Re-mount using the 3 screws and plug in the electric connector. Make certain the water inlet tube is positioned thru the retaining hole before you remount the screws.
• Replace freezer door and baskets.

You might try pulling the refrigerator out and vacuuming the coils in the back of the appliance. Check that you have clearance all the way around the unit so that air can get to the fans. You may need a new thermostat, but hopefully cleaning will do the trick. Check the manual for troubleshooting help before you call a repairman. (Manuals are available online if you have misplaced it.)

JFC2089HTB S/N 10551059GEDOOR LIKES TO STAY AJAR. BEEPER TO NOTIFY ME DOES NOT WORK

Ice maker will not work when we have a steady noise. Aftr a few days the noise will stop and the icemaker will start making ice.

I think the best way to explain how to change the light bulb can be found on page 26 of the=> JFC2089HE User Manual If you have problems with the above link then click HERE and then enter your model number and answer the questions above the plaace you enter model number. I will be here to answer any questions you may have Thanks Sea BreezeYou will need Adobe Acrobat Reader to view these documents. The Adobe Acrobat Reader is available as a free download.

Slide the unit from the wall. Check the control board to see if you see any burnt marks or the burnt smell coming from the control board. Here is a diagram for the location of the board. It is number 21 on the diagram. Here is the part to order in case it is bad.The part comes with a 365 day, any part, any reason return policy.

BFULLAWAY had the answer, I believe. My ice maker does the same thing, groaning and creaking for a few seconds, stopping briefly, then starts creaking again. This is due to ice stuck inside and it will make no ice as a result. Usually I see a piece of ice protruding and knock it out. Happened recently, but I saw no ice. Took a cup of hot tap water (not boiling) and poured it into the compartments where cubes form. (Made sure ice tray was in place to catch water.) I banged on the side and a misshapened cube fell out. Creaking/groaning stopped and unit began to function normally.

It may be informing you it's time to change the water filter. Just a thought

The part number is W10207861, and its a simple repair. All you need to do is remove the light diffuser and drop the whole front piece where the display is by removing any screws . Once you have it down unplug the connections and remove from the machine completly. From there there will be some clips you'll need to push to open the box that holds the control If you need further help, I’m available over the phone at https://www.6ya.com/expert/jason_4570d45317834dd3