Top 20
Whirlpool GLT3014 Gas Cooktop Questions & Answers
Gas doesn't come through to hob
hi,mostly is the problem is in only the line,i think ur line is far in ur cooktop thats why is the gas flow is slow to out in ur cooktop try & try,open ur gas valve for about 3 min or more until the gas is out.
9/3/2009 10:08:23 AM •
Whirlpool...
•
231 views • 0 helpful votes
Westinghouse 808 cooktop clicking noises
Sometimes after a power failure the p c board needs re setting. Turn off the power for a few minutes that allows it time to re set. Turn it back on then individually turn on each element for a couple of minutes.
4/22/2014 5:45:00 PM •
Whirlpool...
•
333 views • 0 helpful votes
The burners pop whenever the gas is on
You didn't mention if it only pops when you first turn them on or that the popping is continuous.
If it when you first turn them on, then I would suspect late ignition. Too much gas build-up before ignition takes place. The spark gap may need to be adjusted or the spark module replaced.
If it happens continuously there may be a short in one of the switches or wiring harness.
3/10/2014 5:43:10 PM •
Whirlpool...
•
145 views • 0 helpful votes
Gas stove tops:
After 3-4 minutes
Hi abbilou_78,
I believe your ignition switches have come in to contact with either water or moisture.
Please read my below Tip on how to fix the problem:
GAS KITCHEN APPLIANCE CLICKING SOUND...
If it does not solve your problem, I'd suggest replacing the ignition switches.
Kind Regards
JEDEMEYER1
* If you found this solution helpful, please rate it
7/30/2011 4:18:06 AM •
Whirlpool...
•
717 views • 0 helpful votes
Gas cooktop. burner turned
Hi joyce_hudak,
Moisture or water have come into contact with your ignition devices, they just need to be dried.
Please follow my directions on the Tip below on how to do this:
GAS STOVE CLICKING PROBLEM...
Kind Regards
JEDEMEYER1
* If this solution helped you, please rate it
9/6/2011 10:34:24 PM •
Whirlpool...
•
114 views • 0 helpful votes
Not finding what you are looking for?