20 Most Recent Whirlpool GHW9300 Duet Washer - Page 9 Questions & Answers

Carefully check the drum for something that would grab the fabric, such as a piece of embedded material in a hole. I would feel all around over every surface, and look at where the agitators meet the drum. Something is there that is grabbing the material. Good luck,

If you don't have Owner's manual and it's troubleshooting, Try this: http://www.manualslib.com/ You may like to have it in the future anyway.

try unplugging it then plugging back in while its on start cyclwe

Its probely the moneter or your inter net kunekchin

Check owner's manual troubleshooting. Sounds like a load out of balance and shut down because of that.

No, the door only swings open from right to left. They made no provision for swapping hinge location on that model, which has recently been discontinued. Sorry.

yes they can be stacked

inlet valve stuck open replace

replace valve

probly the noise supressor capasitor folow mains lead into back of mechine u will have mains lead going into it 2 other going out of it to mech components good place 2 start good luck tom.

i think phillips had something to do with wirlpool at one stage

This is a warranty situation. Contact the seller. Otherwise you can take the panel off under the door. There are three screws on the bottom edge. You lift and pull the panel off. You can then see the drain plug and you unscrew that. If you do that though you will get ALL the water from the tub to spill out on the floor.

There is no way to "turn down" the noise on any washer other than to balance the load of the washing machine tub as it spins. Typically the washer increases noise due to spinning during the rince and dry cycle. This noise is a consequence of the rapid spin rate needed to dry the clothes using centripetal acceleration and removing the water.

1. Disconnect power for at least 30 seconds. 2. Re-apply power and observe for at least one minute. 3. If code re-appears, replace control board (also called ERC or clock). Read more: http://www.appliancepartspros.com/repair-help/whirlpool-fault-codes.html#ixzz3PsUurTNH http://www.appliancepartspros.com

Whirlpool Duet Sport Washer will not drain 21 error

IF AFTER THE MACHINE HAS BEEN OFF FOR A TIME DOSE THE DOOR OPEN? IF NOT THE INTERLOCK SWITCH COULD FAULTY OR THE MOTOR BRUSH WORN or LOOSE CABLE LOOM TO MOTOR, (model number would help)

when the machine is stopped can you empty the residue water that remains by the programme selector? if not check for blockage in the pump(coin), the hose internal blockage ,or at the outlet under sink. I hope this help

seems to be the bearing has gone the drum(inner metal) is rubbing on the outter which is plastic . this will eventually cause leaking