20 Most Recent Goodmans GTVL32W27HDF 32 in. LCD TV - Page 2 Questions & Answers

turn TV on, let the Tv cycle through the three colours, then using the remote press the menu button followed by the standby button. press standby button again and it all comes up working.

andy

Check this site for more details. "Electro-help" is the site name. Search it by google search. You can locate it, either at the bottom of the first search page, or at the top of the second. It is an electronics equipments repair help site in English. It has more details the may help you to do this work yourself.

change your +Volume switch

The problem is not the signal it is in the set--have the set inspected by a service center or a repair person.

Have the remote checked--it can be tested to see if it is the problem--if remote is good but does not work on set the remote receiver may be bad inside the TV.Most shops and some electronic places have a remote tester--point remote at it and press the buttons and if working a light reacts---some digital cameras will also if on react on the little screen they have if this is done.Either the remote or the receiver in the set is most common.

try www.tvs-services.com

tHIS SHOULD HAVE 12 DC INPUT but if it has a 2 on the end then no

I'm afraid I don't have the solution but a very similar problem, although I just get the speaker crackle, rather than any problems with the picture/the TV turning off.

Did you manage to resolve it?

The problem you have described occurs due to a faulty LCD controller(T-CON) board. The board is inexpensive(costs around 40$) is easy to replace. Let me know if you wish to do it yourself so that I can help you find a replacement part and fix it.

Make sure that the electricity is working
Make sure that every connection is in place the
scart connection as well.
Disconnect and wait for 2-5 minutes
and connect and start.

If that does not work look for troubleshooing in the manual or click on the name of your TV here at the top of the page.
good luck
kolbrun

hi there.presumably you get a quick flicker of picture when first switched on?.If so, you will need to replace the inverter board,readily available on ebay.
another problem these sets can have is no picture in the middle,just at the sides, and gets progressively worse over time,until there is no picture.this problem is caused by two 680uf,35v capacitors on the power supply,which burst as they are under-rated budget parts,all too common these days!
hope this helps somewhat!regards,
steve

I can only assume from the detail that you have a bad lback light and probably should have that replaced. The tv uses a bank of florescent lights for the lighting to see the picture.

The causes of this,it is the tv Tuner signal board is having a problems,this problems could be anythings on circuit board it just not completely dead yet,it impossible to pin point to that exact component or components parts,without at alot of eclectronics testing equipments and troubleshooting skills.That the board,where the incomming broadcasting signal wire plug into it.That why it it work sometimes other times it don't.U have some mechanicals skills?U can take things aparts and putting it back together again?Yes.Tries websites like Shopjimmy.com,Ebay.com to buy a whole tv Tuner signal board for the replacement.

if it s a pedastal stand like in the picture there will be four screws holding it inwhere the two poles insert in the back of the tv

Press the exit button or menu button until it goes away