Kenwood FreeTalk XL TK-3101 (15 Channels) 2-Way Radio - Answered Questions & Fixed issues

Search on ebay and see if anyone selling some of these would photocopy the manual for you for a fee.

Simply you read the program by KPG55D and go at ctcss and delete it by pressing the delete key and press enter after deleting.

The Kenwood TK-3101 are programmed through the old DOS based program and a program cord. The only way to "reset" is also through the cord. Finding both the program and cord might be difficult but i do have those and let me know if you need assistance?

tk3101 has nothing to think about. on/off channel select. red light transmitting beep battery empty green is receiving search for kpg tk3101 and kpg 22 from ebay to programm. Only difficult is that xp or win 7 will refuse first times the commport

there are to many options to solve, And to few information given by you 1 first turn on the sound knob (most likely) 2 read the channels of you're equipment and those of you're friends software is all over or use an old radioscanner or freq counter. 3 put new software in all the equipmant. Easiest way

I would suggest you need to check the frequn IRS.

I would suspect that the frequency setups don't match. The only way to know on the TK 3101 is connect it to a computer. I have the cord and program for the TK 3101. Let me know if you need help.

It is a PC programmable radio. You'd need the program and interface cord. if you want I could reprogram for a small fee. Let me know if you need help.

They're paperweights. Sorry.

Check on www.mods.dk, lots of user manuals (and service manuals) available if you join (for a very reasonable fee).

The squelch circuit is open. Adjust it and the noise will go away and the light will go off when no-one is talking.

Try www.radioreferrence.com and check the forums.

Try www.radioreference.com

Increasing the Radio frequency,this could be done,only by programming the radio, Thanks jack

other than check your wiring for rubbed spots or loose connections, I don't know. maybe try swapping parts one at time with your buddy. maybe your headset?

hi, all i can think of is- A, the computer is way too fast for the program you are trying to run, what you need is a really old slow computer or B,

check the COM port settings on your computer.
click start, right click on my computer, click properties, then click on the hardware tab, then device manager.

then there will be a 'Ports COM &LPT' just make sure the com port number is the same one as you are using on the software. Hope this helps.

sometime your program is wrong... so plz go this website and u can get soft the prob :)
this website have sofware :) so nice man!

http://www.twowayradioearpieces.com/Programming-Cable-for-KENWOOD-C178-1.htm

Low batt. Charge for 8 hours and enjoy. It should work

Check which PL tones they are using (CTCSS, eliminator codes) and set your to the same.

If you are replacing radios and connecting them to your bike and it is doing the same thing. Its not your radio, it is something else. I am not familiar with this autocom gizmo you talking about, but if you take your radio and it works on another bike, then that should tell you its not your radio as well. I suspect this AUTOCOM thing is the culprit