2001 Toyota Prius "reset check engine light" Questions

...reset check engine light ? what kind of car do u drive 96+you need OBDII scanner to read and reset light. NEED CODE SCANNER TO ERASE CODES OD DEALERSHIP ERASE CODES BUT IF THERE IS PROBLEM IN ECM ...

...reset engine light I left the key on and killed the battery. Recharged battery and car runs for 5 seconds then quits and check engine light comes on. Get the car be scanned thoroughly to locate the ...

it off or disconnect the battery for five minutes and the computer will reset. If it comes back on your local auto parts representative can harmlessly run a code check on it to see what the problem is

...check engine light came on. We took it to the dealer and they said the code was P3108. They reset it and could not get it to come back on. They said they thought the visor mirror light may have been ...

...Check engine light comes on and stays on until it's reset. No codes come up and the car runs fine until the next time the light comes on. 100+ temp in stop and go traffic causes it. Any one else had ...

...check engine light comes on and you have a loss of power this could mean that the ecm has put the vehicle in the self protect mode. the only way to reset this is with a diagnostic scan tool that will ...

reset my oil change indicator. How do I do this? A 2002 Prius does not have an oil change indicator. And it doesn't have a power button either, so the first "solution" is wrong. If the engine light is

...reset is a braking sequence: most commonly is turn key to on position, pump gas three times. Key off, start car. I would advise to check you fluid levels and make sure you replaced the drain plug and ...

...check the resistance of them using an multimeter to see if they are within spec. I forget exactly but it's something low like 9-12 ohms at 68F. If you have Fuel/Air sensors instead, it's dealer ...

reset my check engine light on my 1997 T600 Kenworth 2010 KW T800 How to reset engine check light ' TruckersReport.com ... www.thetruckersreport.com > ... > Kenworth Forum Nov 8, 2011 - Is there a way