2001 Honda Accord "cylinder head bolts tightening sequence" Questions

...cylinder head dowel pins and the oil jet must be in place. Refer to the illustrations if necessary. Install the head. Lower it straight down onto the block, aligning it correctly. Apply clean engine ...

...cylinder head temperature must be below 100 degrees F (38 degrees C); allow the engine to cool several hours if the car has been recently driven. Turn the crankshaft pulley so that the number one ...

cylinder head bolts. Tighten the cylinder head bolts is sequence to 29 Nm (3.0 kgf-m, 22 ft. lbs.). Use a beam-type torque wrench. When using a preset type torque wrench, be sure to tighten slowly and

...of pressure and how many passes needed to torque. Thanks Install the cylinder, then tighten the cylinder head bolts sequentially in 3 steps. step 1. 29 ft. lbs. step 2. 51 ft. lbs. step 3. 72 ft.

...cylinder head cover. Remove upper cover. Remove dipstick and tube assembly. Remove crankshaft pulley. Remove adjusting nut rubber seal and remove lower cover. Timing belt/balancer belt removal Loosen ...

...cylinder head (valve) and upper timing belt covers. Turn the engine to align the timing marks and set cylinder No. 1 to Top Dead Center (TDC). The white mark on the crankshaft sprocket should align ...

...cylinder head torque specs and sequence Cylinder head bolt tightening procedure: CYLINDER HEAD BOLT TIGHTENING SEQUENCE: INTAKE SIDE 8 4 1 5 9 7 3 2 6 10 EXHAUST SIDE In sequence, torque the cylinder ...

...cylinder head bolts using the specified engine oil. Install the cylinder head bolts. Tighten the cylinder head bolts in 2 or 3 steps in the sequence shown to 76-81 Nm (56-60 lb-ft). 1.9 liter Apply a ...

...cylinder head tighten torque head tighten torque is important to tight all 4 bolts evenly Have a look on this link. You may be able to find your car: SPECIFICATION LOOKUPS Cylinder head bolts are ...

...cylinder head bolts in the following sequence: Tighten Tighten the cylinder head bolts?(1-10) in sequence to 30?Y (22?lb?ft). Use the J 45059 to rotate the cylinder head bolts?(1-10) in sequence an ...