1991 Ford Mustang "spout connector" Questions

spout connector plug that hangs from the distributor? Yes, the spout connector needs to be in place. It controls the timing advance electronically of the motor based on the RPM. This is why you remove

...your wiring connections to the distributor and make sure they are connected properly. To set the timing you will have to remove the spout connector, set the timing, then reinstall the spout

1988 mustang 2.3 liter,no turbo,natural.Where is the spout connector located The spout is located in the wiring haness next to the Ignition module, it is a square plastic shorting plug.

...spout connector (a grey jumper located in the engine wiring harness either near the code reader port or the distributor) and put a timing light on the #1 spark plug wire.  Aim the light at the ...

...gt 5.0 HO 5 speed 10 DEGREES BEFORE TDC WITH SPOUT CONNECTOR DISCONNECTED , I THINK THAT ON THAT MODEL THE CONNECTOR WAS LOCATED IN THE WIRING HARNESS AT THE DISTRIBUTUR CONNECTOR HAS YELLOW ...

...SPOUT connector jumper. It lies just under the distributor and is rectangle shaped. Connect timing light to #1 spark plug wire (Front passenger side) Timing should be at 10BTDC. If not correct then ...

...spout connector (little grey plastic jumper in the engine wiring harness... I think on the '95s it was near the distributor); if the spout connector is left in the computer will pull timing ...

...spout plug connector. Remove it because with this in the computer will keep adjusting the timing by itself and you will not be able to set the timing. So with the spout connector removed and the ...

...SPOUT CONNECTOR WITH THE CAR OFF , START CAR, ADJUST TIMING, THEN WITH CAR STILL RUNNING RECONNECT IT. THE SPOUT CONNECTOR LOOKS LIKE A DEAD END WIRING HARNESS THATS JUST TO THE RIGHT OF THE ...

...spout connector location 1989 ford f250 xlt need help locating spout connector for 1989 ford f250 xlt lariat if you look on the distributor you will see the large connector for the mudule bolted to ...