Show spout connector location 1989 ford f250 xlt

My parts book shows a speed sensor in the side of the transmission where the cable used to be.

We do not have this deatiled information. It would be in the Ford factory service and repair manual which is not free to share on the Internet. You can get a used one here.

Here is a site to look at, has pictures that may help, also other wriitten directions that tell of other possible locations to find it...http://www.ford-trucks.com/forums/830059-where-is-the-spout-connector-on-my-93-f150-5-0-a.html

Sounds as if you brake light switch is not working or adjusted properly,check for voltage to the switch then depress the brake pedal and make sure you have voltage on the outward side of the switch if ok check the bulbs at the taillight assembly

possible low pressure switch located on the accumulator

The "Inline Spout Connector" is used to control the engine timing by dis-connecting the timing control from the timing control unit, and you must remove the inline spout connector before you can change or set the ignition timing, and if the inline spout connector is missing, then the engine timing will not be controlled by the dura-spark control unit, the check engine light should be on, and the engine will perform poorly. Usually it is located out by the distributor or over by the dura spark control unit.

It is normally a small squared looking grey plastic thing that should be in the end of a wire connector, and that is the only thing that will on the end of that wire connector, and it is basically just a jumper plug. Here is a similar image of what you should be looking for.

if you have 2 tanks you have 1 in each tank and 1 on the frame

The oil fill spout should be located on the valve cover (drivers side if I remember correctly).

check on the foot panel on the right of the pasanger side, there is usually a hole in it where you can reset it.