Question about Seagate BARRACUDA Computers & Internet
Installation of the drive and setting of jumpper to make it either as a master or slave During the boot process you will see on the screen to press a certain key to enter setup Press and hold that key
Question about Seagate BARRACUDA Computers & Internet
what are the settings for a slave drive? http://www.seagate.com/ww/v/index.jsp?vgnextoid=66cc26a2c88ef010VgnVCM100000f5ee0a0aRCRD&locale=en-US&reqPage=Legacy no jumper at all is the slave ...
...slave removed all jumpers. During the boot process you will see on the screen to press a certain key to enter setup Press and hold that key during the boot up process to enter BIOS the scroll down to ...
Question about Seagate BARRACUDA Computers & Internet
Slave is no jumpers selected Here is a manual for your model for reference: http://www.seagate.com/support/disc/iguides/ata/cuda7200ig.pdf normally most harddrives are the same, copy the other one see
Question about Seagate BARRACUDA Computers & Internet
Barracuda 7200.10 (how to make it slave) The map isn't on this model of hard drive. I need to slave it out but there is no mapping on the hard drive like you would normally find. Seeing as different ...
configure hard disck to slave I WANT TO KNOW HOW PUT SEAGATE BARRACUDA 7200.10 TO SLAVE you have a diagram on the hard drive that shows you where to install a small jumper tab. Make sure you also ...
slave 1) Open your computer case 2) On the back of the drive where the connectors are, you have jumpers. These small plastic tabs change the function of your hard drive. All hard drives have a special
Question about Seagate BARRACUDA Computers & Internet
slave. how can i do this? Look at the jumper settings. These jumpers are located near the data cable and the power port of the hard disk. Usually by default, this jumper is set to "Master". To make it
jumper settings for slave Page 21 in this manual shows the jumper should be removed to set this drive as a slave. You could also position it over the second column of pins, that is the cable select ...
Question about Seagate BARRACUDA Computers & Internet
How do to install slave drive Seagate Barracuda 7200.9. Does it has to be to the motherboard or to a card in my computer? How do I set the pins in what order? if y0our going to slave one hardrive you ...
15 questions posted
Usually answered in minutes!
161 Questions
116 Questions
74 Questions
22 Questions
19 Questions