Maytag MAH6700AWW Neptune Front-Load Washer "top loader continuous test" Questions

Top Loader washer stops with 33 minutes remaining in the cycle and will not continue. The door will also not unlock even after I unplug the machine and plug it back in. When we put it in service mode,

...top loader or a front loader. I'm going to go with top loader. Check your lid switch. if that has gone bad the machine will sit there and look stupid i have one these washers and it just stopped ...

...loader HI, this will occur if the unit is having issues with the filling process during the wash cycle. Check The inlet hoses, to make sure they are not kinked in any way, or twisted. I would ,also, ...

...top I found actually a very useful document stored in the control panel itself. It is called "Schematic Mini-manual LED Washer" and it contains a set of schematics for the electrical system and an ...

...The signal out test is the blue/white wire, 0- 3.0 volts. Over all its a bad design, just get a cheap top loader (with out all the fancy computer stuff), these will run for 15 years, very little ...

Samsung top loader just continues to drain and water valves wont open to allow water in drain pipe is above the drum level Washer Not Filling Water Inlet Valve Testing Troubleshooting

water, then does nothing. Is it a top loader of front? It almost sounds as though you have a defective timer. If you can do a continuity test on the timer with a volt-ohm-meter or through a technician

...a multimeter or ohmmeter. Check for continuity. A lack of continuity means a bad switch. Really sorry for your trouble and I hope this helped. Best wishes. my ge washer top loader overfills with ...

...top loader washing machine drain motor spins all the time? With the washing machine off, the drain/ waster pump continues to spin. This is with only the power switch on at the wall socket. All hoses ...

...loader washing machine. Today it is not working, as if there is no power. The trouble shooting guide has not helped. The electric plug is fine (another appliance tested OK). I should take the top off ...