Question about Canon DR Office Equipment & Supplies
...it to clear? Scanner dead until error is cleared. There may be a samll shred of paper stuck in the sensor, Search thoroughly. S. Mohan It's going to be the sensor or the circuit board. Make sure ...
Question about Canon DR Office Equipment & Supplies
...It sounds like the Motor only vibrate but not Move the tray. I replace the Motor of the tray, the Sensor that realize that the tray is down and the hole caple from the tray but the Problem is the ...
Question about Canon DR Office Equipment & Supplies
...will not lift up with paper on it. It then says no page found in feeder. Thanks. There is a paper sensor just under the rolers in the lifting tray. Clean the area thoroughly with a damp cloth. Keep ...
how to replace sensor in DR7580? Which sensor do you need to replace? These machines have several sensors throught the machine that assist with lifting the tray, watching for staples, and even double ...
...then just stays there and doesnt come down.. Can you help what might be wrong?? Thanks There is a sensor under the paper tray and when powered On, the tray goes to home position (HP). If the sensor ...
Question about Canon DR Office Equipment & Supplies
...door is open but everything is closed More common reasons are paper jam, dust/dirt, or a faulty sensor. So, check for even the smallest pieces of paper, especially in the scanner area, use ...
Error P00 My scanner gives a P00 error indicatinf a paper jam. There is no jam. It may be bad sensor. Any ideas on how to fix or who can repair. A few easy things to try. First off, have you power ...
A document was skewed. Please remove the document and scan it again(-4710) There are sensors at various locations inside the scanner. If a document is skewed slightly, the scanning software can deskew
Question about Canon DR Office Equipment & Supplies
...page was found in feeder" message appears on my computer. At the bottom of the tray there is a sensor for checking "Home Position". When you power on the system initialises and the tray goes to ...
SAYS STAPLE DETECTED BUT NO STAPLE Try cleaning the staple detection sensors in the machine. Most of the time if you blow air gently into the machine to clear dust from the sensors. If a stapled paper
216 questions posted
Usually answered in minutes!
58 Questions
64 Questions
33 Questions
38 Questions
28 Questions