Brother MFC-620CN All-In-One InkJet Printer "picking paper bottom tray" Questions

...picking up paper. If OK, take out paper tray and set on a table, the gear closest to the table has a flat area that needs to be level with the bottom of the tray or the table. If slanted up you need ...

...paper loaded on top at the back bottom feed from a tray underneath? Top feed take one sheet of paper and gently push it down whilst the printer is trying to grab it. Tray feed - take tray out make ...

...paper from the Manual Feed tray on the top of the printer rather than the main tray at the bottom. You can fix this from your computer- when you go to print and the print dialogue box comes comes up, ...

...table and see that the gear on the side with a flat spot is level with the table or the bottom of the paper cassette. If up a little, you need to bend the part that lifts the paper until it sits

...bottom of the the back panel. It is a curved panel on the back you can feel if you reach behind the machine from the middle of the doc feeder, it snaps right back in. I had pulled one of the tabs out ...

...bottom paper tray is full of paper. This just started happening. Any ideas? Jay [email protected] Hi This is unfortunately very common issue about MFC-8460N, There are few steps you can try, Set to ...

bottom u will have Scanners and Camera, click on Brother MFC-7420 USB Than if the window pop ups than click on Microsoft Scanner and Camera Wizard Now u will have new Window "Scanner and Camera Wizard

...paper at all, despite the wheels at the bottom(side)were rolling. 1- either the tray is not lifting the paper to meet the rollers ( which may indicate a motor problem) or the rollers are not coming ...

...paper feeder roller might have reduced in size to sense and picking the papers from the tray. Test run can be done by printing in the open tray (which is available on the top.. If it is able to pick ...

...paper at the bottom Try to put paper in the manual feedd tray. If it prints, then put more paper in the auto-load tray, if that doesn't work, check the EXACT location of the clips and position ...