Onkyo TX-SV636 Receiver "6 speakers" Questions

...low frequency speakers (woofers) measure about 6 ohms because the addition of crossover will bring the impedance up to 8 ohms. Even without the crossover, 6 ohms will not harm the amp or ...

...speakers are 6 ohms. Would this set up cause the Teceiver to overheat ? Would really appreciate any advice please? Stephen. The best thing to do is place a VOM meter to confirm that there are 6 ohm ...

...6 ohms or am I stuck with having to have two 8 ohm speakers for each side if I want the presence feature to work. Also if I wanted to run some very large front speakers instead of the presence ...

...receivers so setting the receiver to 8 ohms and running the 6 ohm speakers shouldn't be a huge problem. I wouldn't crank the volume though if i were you but at a decent level you should be

...6 ohms if your speakers sit between 6 and 16 ohms. Incorrect settings can result in the 606 going into power protection after prolonged use or at higher volume. Page 96 covers testing for unexpected ...

...6 pair of speakers (12 total) via one stereo receiver A friend has a business. He has 6 pair of speakers, making a total of 12 speakers, installed throughout the restaurant. He wired all of these ...

...speakers at 6 ohms. So, am I taking any significant risks by hooking both sets of speakers to the same amp. I did this with my previous amp and it seemed to work ok, however, one channel did fail but ...

...not played at full volume. But be sure to set yamaha for 6 ohm speakers. Using only 4 ohm speakers makes the amplifier work more hard and produce more heat, that's why you can't use it at high

...cable. Did you set the speaker impedance (Page 33 and 117) to 6-ohm min. AND - the manual does actually say "the impedance of each speaker must be 6-ohms or higher" for all BUT the Front

...arise when you try to use a Receiver with a higher output impedance than the Speakers input impedance.Receiver 6 ohms speakers 8 ohms......YES..Receiver 8 ohms Speakers 6 ohms.......YES, WITH ...