My passenger side rear window will not go down or up when the button is pressed (driver door or its own button) nothing is heard. Where is the fuse for this? 2007 Corolla CE, all of the other windows work.

You say the driver window works? wouldn't be a main fuse or fusible link then -driver door locks and window wouldn't work either. Each door has a module inside (computer) . The driver door has a circuit breaker power feed an a fuse DDM fuse 10amp located in rear junction block circuit breaker is located in under hood maxi fuse block. The circuit breaker also feeds battery voltage to the other door modules too. PDM - passenger door module fuse 10amp located in the instrument panel fuse box and the RDM - rear door module RDM fuse 10amp located in the rear fuse box - under the back seat.

Each power window is connected to a permanent magnet motor. The motor raises or lowers the glass when the door module applies voltage to the motor. The direction the motor turns depends on the polarity of the supply voltage provided by the associated door module. The 2 front doors have their own separate modules. The rear seat contains a single module, which controls both of the rear power windows.
A serial digital communications link, called the simple bus interface, is used for communications between door modules and the driver's door power window switches. The use of serial digital communications allows the use of a single wire to convey switching information between the power door lock switch and the driver's door module (DDM). The serial communication is also used in order to transmit switching information from the DDM to the other 2 door modules.
The door modules apply battery voltage of the correct polarity to the respective window motor when any local, or power door lock switch, UP switch is operated, driving the window up. Battery voltage is applied to the respective window motor in the opposite polarity when any local, or power window switch, DOWN switch is operated, driving the window down.

Driver Door Module (DDM)
The driver's door module (DDM) directly controls the driver's door window motor and the express down window feature. The DDM sends window UP/DOWN messages received from the power door lock switch to the passenger door module (PDM) and to the rear door module (RDM) over the simple bus interface (SBI) line. The DDM also contains a class 2 data link which communicates with the other vehicle system modules. The left front power door locks and the outside power mirror are also controlled through the DDM.
Passenger Door Module (PDM)
The passenger door module (PDM) controls the passenger's door window motor. The PDM controls the passenger's door window directly from the right front power window switch or from instructions over the simple bus interface (SBI). The right front power door locks and the outside power mirror are also controlled through this module.
Rear Door Module (RDM)
The rear door module (RDM) controls both of the rear door window motors. The RDM controls the rear windows directly from the rear door window switches or from instructions over the simple bus interface (SBI).

that is a safety feature to stop children playing with windows. On my Lexus ES330, there is a button just ahead of the driver's 4 button window control. It controls whether passengers can use windows or not on the other three doors. Consult your manual

Page 55 and 56 refers to it as a child safety switch, it is marked 'S' on the diagram and is behind your 4 switches on the right.

Child safety switch is pressed in, the
When the safety switch 'S' in the switch lights up. The window switches in the rear doors are deactivated.

https://www.manualslib.com/manual/396576/Audi-A4.html?page=56#manual

..

The windows need to be re-learned.
- Park the car on level floor. Shift the gear lever to P or N. Pull up the hand brake. Start the engine.
- Sit on driver's seat. Lower the driver side window. Keep the button pressed for three to four Seconds after the window glass sits completely.
- Move up the window glass and do the same as above.
- Do the same with passenger side window glass while sitting on the passenger seat.
- Repeat the same procedure for rear windows one by one from their own buttons.
- Sit on a drivers seat and operate all the windows one by one.
Note:
If the problem persists, pull up the body diagnostic error codes with Diagnostic computer or re-learn the windows with the same machine.

Check the fuses in the fuse box.

You also have Circuit Breakers for your windows, Or your Master Switch ,You can Test the Driver Control Switch or the rear switches by removing the Switches and using the connector Plug and a Jump wire try jumping accross the wires,if they go up or down you could have a Bad Switch,if nothing moves more than likely your Window Motor is bad. BUT first CHECK your Circuit Breakers ,It could be Labeled as accessery Relay or circuit Breaker.

This sounds like a stuck switch,try to unplug the switch (drivers side window) first and it should cure your problem.Let me know if this does it,,if not i will help you solve this issue

The motor on the passenger side is shorted and is now tripping the circuit breaker. Odds are, the back window motor is also bad. You have to take the panel off to check the motor. You can power it directly to verify it has failed.

you have to run a power wire to the motor in the door and press up on the window button it should go back up if not then you need to change the button hook up or the motor

Most likely the RX lost the ECU program/ configuration. Need to reset the config. It is a sequence of buttons that need to be pressed.
You have to do the exact sequence of each door as it blinks or you cannot use your windows. Here are the steps.

first the driver window button will blink. lower the window half way down then raise the window up to max and hold the button for 5 seconds. Then the front passenger window button will light up and you do the same thing for each door as it lights up. It goes driver, front passenger, rear passenger side then rear driver side then do your sunroof by hitting the tilt button hold for 5 seconds and that calibrates all the windows.

I just bought a 2007 accord and its having the same problem. Was there any resolution?