20 Most Recent
2008 Chrysler Town & Country Questions & Answers
What would cause antifreeze to come out of the overflow of the reservoir?
Remove radiator cap when car is completely cold. Refill radiator look to see circulation when cap starts turn heater high. When thermostat opens water will be drawn from overflow into radiator. If this does not occur faulty thermostat is probable cause if no circulation change water pump. Refill water to correct levels and car should run correctly
Code 2200 - ABS Module Malfunction
The cpu moniters all the systems you mentioned so any one of the sensors can be faulty and put the light on. In my reference book on codes OBD-11 P2 the code quoted refers to nitrogen oxide sensor bank 1 circuit malfunction causes wiring NOx sensor or heated oxygen sensor 3 bank1. Wiring short to positive---short to ground ---ECM unless the ECM controls the abs etc I would be seeking a second opinion as to the problem My reference is Auto data diagnostic trouble codes Engine management systems--2012
What kind of power steering fluid for 2008 town and country van
My 08 T&C requires ATF +4. This is per the manual and many online forums. Do not use regular p/s steering fluid like I did. It will create a winning sound and you will have to drain and refill the resivor with the right stuff to correct it. Hope this helps. ??
My 2008 Chrysler town and
Unless you can find a local mechanic who is very familiar with this problem, it is most likely you will need to take this to a Chrysler dealer, as it is either a computer problem or an electronic problem. God bless your efforts.
2008 Chrysler Town & Country. Need to remove
There are about 10 fasteners holding it in place. Check with your library to see if they offer online car repair manuals. If not, invest in a 1-year subscription to alldatadiy.com and print out the diagrams.
2008 Town and Country air
when an ac unit that is working well in the cooler parts of the day but fails when it is hot , it is indicated that there is excessive gas in the system
ac gas is not added by the can but by reading the pressure on 2 gauges
one connected to the inlet side of the compressor and the other to the high pressure side of the compressor ( there are forums where gas has been added by the can that has resulted in hose failure and compressor damage)
it works like this ac liquid gas is released in to a low pressure area in the evaporator ( under the dash) and the heat of the car boils the liquid off. That makes the air cold
the gas is then sucked in by the compressor and converted back to a liquid in the condensor in front of the radiator
there the heat from the compression of the gas is removed by the condenser fan and the liquid is then sent back to the evaporator
If you have excessive gas in the system it cannot be compressed back to a liquid (too much heat in the gas to transfer to the air)and so the high pressure side safety switch turns the compressor off to prevent damage
hence no cooling in the hottest part of the day
as to you statement about the amount of water on the road
If the humidity is 14-20 % there is very little water vapor in the air for the evaporator to remove and so there will be little water separated from the air in the car
AC units cool the air in a car by removing the water vapor (humidity) from the air in the car ( humidity is what makes you sweat and feel uncomfortable as you will know when it is 80% or higher )
using an a c along with the heater ( climate control) is the quickest to defog a windscreen
So have the ac tested for correct pressure by a professional accredited ac shop
Not finding what you are looking for?