How much does a 2003 Kia Sedona wiper transmission cost to repair? Intermit wiper mode does not work. Wipers gets stuck in up position. Regular speed of wipers work fine when moving consistently. But when in intermit mode, wipers get stuck.

Have a qualified repair shop check it out . Electronic module involved , WCM - wiper control module . May have code's stored . You have no clue as to how it works.

The windshield wipers are controlled by the wiper control module and the driver-operated multi-function switch on the steering column, with the ignition switch in RUN or ACC position.
There are four modes of wiper operation: OFF position, the wipers move to and stay in the park position; Interval position, the wiper control module causes the wipers to cycle, separated by pauses, pause time length being determined by switch location; LO position, the wipers will operate at low speed continuously; HI position, the wipers will operate at high speed continuously.
The windshield washers are controlled by pressing inward on the wiper switch end of the multi-function switch. The washers will operate as long as the switch is depressed. If the wipers are in the OFF or Interval operating mode, the wipers will begin in LO speed and the washer pump will pump fluid from the reservoir to the nozzles. When the switch is released, the wipers will complete three cycles and then return to their previous setting. In LO or HI mode, no change in wiper operation will occur during washer operation.
The washer fluid level sensor is in the windshield washer reservoir (17618) and is monitored by the hybrid electronic instrument cluster (HEC) and displays a WASHER message when the fluid level is low. The washer fluid level sensor and windshield washer reservoir are replaced as an assembly.

• The Low Wiper Speed Does Not Operate Properly

• Multi-function switch.
• Wiper motor.
• Circuitry.
• Wiper control module.

• GO to Pinpoint Test C .

• The High Wiper Speed Does Not Operate Properly

• Multi-function switch.
• Wiper motor.
• Circuitry.
• Wiper control module.

• GO to Pinpoint Test D .

Not sure what you mean by "sort" but if the wipers are not moving but you know the motor is running then you have a broken wiper transmission. I suggest you take it to a mechanic.

there is a body control module behind the fuse box under the dash. it runs the wioers ,widows ,and locks,and much more

Their is a relay under the dash board that controls the wipers some times this burns out un plug this you will need 2 remove the fuse panel to do this with the ignition switch the wipers on then identify which unit it u will see small coulerd box's about 25 mm square when u fined the right one replace this with egzaxtly the same type this should sort it 4 u

You need to remove the front panel under the windscreen under the bonnet and check if wiper links are connected.

The transmission linkage has come off,you will have to remove the wiper motor and the panel under the wiper arms,along with the wiper arms to access the problem.

where do i find the fuse for front/rear wipers on a kia sedona 2.9 crdi. When i am in the fuse box all i see is relays and no fuses.

The self parking mechanism in the wiper motor assembly has failed, most likely the "emf brake" built into the motor itself. If the self parking microswitch was broken (another common fault) then the wipers would simply keep running until the ignition was turned off.

The only solution is to either get an auto electrician to see if the motor assembly can be repaired or to replace the entire wiper motor. Repair is probably the better option as it's an expensive part.

perhaps the wiper motor is bad.

HI,CANNOT SUPPLY DRAWING,BUT IF YOU CAN MOVE WIPER ARMS FREEY ON SCREEN,ONE OF THE BALL JOINTS HAVE JUMPED OFF,YOU NEED TO REMOVE THE PLASTICS TO GET TO IT AND JUST SNAP JOINT BACK ON.THANKS