SOURCE: hyundai accent '02 inside door handle & Lock removal
Removing the door is very tricky, trust me on this. I ended up breaking it the first time, so please learn from my mistake.
1. Remove all visible screws: 2 at bottom of door, 3 on front near
hinge, 1 on inside the door lever. You will need an average size
phillips screwdriver to do this.
2. On the door handle itself, you will see two circles. Pop the front
one out. You will need a LARGE size phillips screwdriver to do this.
3. Once screws are removed, take a (standard) flat-head screwdriver,
preferable one with a large face, and pry the triangular piece of
plastic (that covers the outside SIDE mirror) off. This will aide in
puting the door panel back on...TRUST ME!!!
4. Take the same flat-head screwdriver, and pry behind the door lock
(at the same time, push forward toward the door hinge). The assembly
should pop out.
5. Gently pry the door panel from the door, making sure not to break
any unnecessary pieces along the way. The door panel should be hanging
by the window sill opening.
6. This is where it will get tricky. It is advised that you use help
with this part: Angle the door panel at a 45 degree angle. AT THE SAME
TIME, slightly bend and twist the door lock handle until it fits
through the hole. You will see the 3 pegs the held it in the door from
before. Also note: Be careful not to break the 2 poles that are
attached to the lock.
7. After popping the lock through the hole, you should be able to lift
the door upward, and off the sill. Repeat these steps in reverse order
to re-attach door panel.
Be careful not to rip sound-deadening paper found on inside of door
unless you intend to remove or replace it! Not only does it prevent
dirt and moisture from entering your door (and possible rusting it from
the inside out), but it makes your speakers sound better too!
-SportTunerFreak
**It is also recommended to put a tiny bead of silicone on the inside
of the door panel to help suppress any rattling, and prevent moisture
and dust from entering. It also helps your screws obtain a tighter fit.
Hope this helps!
SOURCE: How do I remove driverside inside door panel ?
door panel is holding by dozen plastic push pins.
strat from the button. use a screw driver or putty knife. pull the panel towards you. be careful not to damage the push pins. go around the panel toward the door hinger then the otheer direction toward the lock.once you have panel seperated from the door. push up the panel to clear the glass. (it is easier if the window is all the way down). pull back the plastic (don't destory it). you need to put that back later. now can get access to the galss and what ever else you are looking for.
SOURCE: remove door panel for 2002 toyota camry
I was looking for similar and had just seen this.. Hope this helps..
http://www.bodyshopzone.com/archives/trim/door_panels/Toyota/Camry_2000_front/removal_f4.html
SOURCE: how to remove the driverside door panel 2001 325i
with a screw driver remove the mirror control, that comes off its another screw there i had the same problem
SOURCE: How to remove drivers door panel from 1997 Cadillac Deville.
try to look at stress point on door by handle normally two screws and under neath panel to screws also disconnect side panel for side mirror door of using panel popper
35 views
Usually answered in minutes!
×