20 Most Recent
Questions & Answers
No sound from speakers
I ran into the same issue... everything was working correctly from the display screen (AM,FM,XM,iPod,Bluetooth) picking up stations, and all controls were working, but no sound at all. I called the dealer and found out there is a reset button that reboots the entire nav/audio system. It is a pin-hole located just to the left of the CD slot on the console. You will need a paper-clip or somthing that size to push it. Hold it in for a few seconds while the system is on and it will shut down and reset. I have to warn you that it does erase almost all of your presets, but did seem to keep my Bluetooth pairings and my nav address book. Good luck!
on Apr 12, 2020
Tire wear 2011 hyundai elantra
take the car to a suspension specialist shop and have the rear wheels aligned first
have the suspension checked for worn mounts or bad springs
it is very important that the rear end is aligned before the front end
suspect that the suspension rubbers need replacing as it is over 6 years old
the tyre rotation is a myth perpetrated on drivers to sell tyres
when the tyre construction was cross-ply and not radials yes rotation then on cross-ply tyres could get the wear to even out but with radials once the wear is started then the tyre continually wears in that pattern regardless of which wheel it is on
even if you take that tyre of the car and put it on a trailer , it will still continue to wear in that pattern
tyres are no longer rotated but simply put front to back on the same side other wise the belts flex in a new direction in the tread and fail earlier that expected
besides that fact that tyre rotation will not allow you to monitor for suspension problems or wheel alignment problems and cost you 4 tyres at a time instead of two
on Aug 20, 2017
Backup camera working intermittently
You are better off contacting the dealership to have these items looked at. Depending on warranty, it may be a covered item. And if this issue results in a problem with the display and not the camera, many of today's newer cars have these systems VIN programmed, which will put you in the dealership anyway
on Dec 02, 2014
How to replace brake line on front brakes 2001 hyuandi elantra
Hose is held to suspension strut with c-clip, loosen and retighten union joint while still in clip for ease of undoing. then remove clip holding hose with pliers
Top up reservoir and to avoid fluid loss, Clamp existing rubber hose off above Wheel cylinders callipers. Spread brake pads slightly to clear disc rotor edge then undo callipers from hub - suspend from strut with cord or wire and unscrew old pipe. Immediately replace existing with new hose to callipers. With master cylinder reservoir sealed airtight undo union nut at top of existing rubber hose where clipped to strut. Replace existing lower hose fitting with new hose.Tighten union. replace c clip and bleed brakes at nipple on callipers until all air out of lines.
Job done road test for hard pedal repeat bleeding as necessary.
on Jun 03, 2019
Not finding what you are looking for?