2004 Toyota Sequoia Logo

Related Topics:

Joyce Williams Posted on Mar 06, 2017

I need a main wiring harnest for a toyota sequoia 2002 4.7 rwd.

It's the main harnest that runs from the motor to the passenger side of the transmission

5 Related Answers

Anonymous

  • 1861 Answers
  • Posted on Sep 19, 2008

SOURCE: 2002 toyota celica power door lock problem

Are you hearing any noises from the pass door when you activate the lock switch? If not, the power door lock solenoid has failed, and prob needs to be replaced. Pull the door panel & check to see if it is getting power to the solenoid in lock & unlock. If it has power, the solenoid is def bad.

Ad

Anonymous

  • 243 Answers
  • Posted on Nov 10, 2008

SOURCE: 2002 toyota sequoia stalling

Looks like the idle is too low. May be the car is due for a tune up. Cheers.

Anonymous

  • 1861 Answers
  • Posted on Dec 22, 2008

SOURCE: driver side wiper wont work

One side does not work? Can you move the arm with your hands? If so, look for a loose nut that holds the wiper arm on. Remove the plastic trim on the wiper arm base, and tighten the 12 millimeter bolt. Please advise if this helps.

Anonymous

  • 154 Answers
  • Posted on Aug 17, 2009

SOURCE: toyota sequoia trunk locked

remove back panel. be careful not to braek it and you can move the lock with a screwdriver tounlock it

kirtec auto

  • 1348 Answers
  • Posted on Sep 09, 2009

SOURCE: DIAGRAM FOR 2002 TOYOTA SEQUOIA STARTER REMOVAL

the big red cable from the battery goes right to it.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

2002 Sequoia Fuse location for driver's power rear view mirror-which box and what number is it.

Fuse Box Diagram Toyota Sequoia (2001-2007)

https://fuse-box.info > toyota > toyota-sequoia-2001-20...
2001, 2002 - The fuse box is located in the left side of the instrument panel, behind the cover. The location of the fuses in the passenger compartment: ...

Toyota Sequoia (2001 - 2002) - fuse box diagram - Auto Genius

https://www.autogenius.info > toyota-sequoia-2001-200...
Aug. 21, 2016 - Toyota Sequoia (2001 - 2002) - fuse box diagram · Engine compartment · Instrument panel · Fuses (type A) · Fuses (type B) · Fuses (type C) ...
2helpful
1answer

Where is the bank 2 sensor 2 oxygen heat sensor on a 2002 toyota sequoia?

It's on the right (passenger) side after the catalytic converter. I hope this helps. Take care.
0helpful
1answer

Cigarette lighter and power outlet sequoia not working

wire connection has come loose or un done OR a wire has been cut through (if all the fuses are pulled and checked-not simply looked at in place). you will need wiring probe to check it all out.
0helpful
1answer

Door locks unlocks

Sounds like the main wiring loom into the door has been damaged.
Check near the hinges, where the door swings, to see if any damaged wires. Does the door lock and unlock from the drivers side switch?
5helpful
1answer

2004 Sequoia B2S1 o2 sensor - where is this located and is it easy to replace? Thank You!

Toyota Sequoia has 4 oxygen sensors... two on each side. The ones in front of catalytic are position one, and, after are position 2.

Bank 2 is on passenger side, Bank 1 is on driver's side.

Hope this helps (remember to rate and comment this free answer).
0helpful
1answer

Where to find the Chassis Number of 2002 Toyota Sequoia

  • Should be on the passenger side fenger on the chassis leg.

Regards, Tony
2helpful
1answer

Where is the o2 sensor located on a 2002 toyota sequoia

There are 4 of them. Two on each exhaust pipe.

One will be before the catalytic converter and one will be after.

Bank 2 is on the passenger side of the car.

Bank 1 is on the drivers side.

position 1 is in front of the cat position is behind the cat.

Each sensor is referred to by bank 1 sensor 2, etc etc.
You have to get at them from under the car. The rear ones are easy to remove the front ones can be an absolute nightmare sometimes.
0helpful
1answer

Rear window wont go up in 2002 toyota sequoia. all other windows work. can it be a fuse for just that window?

no the motor is stuck remove the back door panel then the 15 screws to acces the motor try tapping the motor while having someone work the switch
2helpful
1answer

Want to fix the passenger side mirrow motor for toyota sequoia 2005

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you can remove the bolts holding the mirror onto the door and disconnect the cables from the mirror going into the door
Not finding what you are looking for?

72 views

Ask a Question

Usually answered in minutes!

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...