20 Most Recent 2003 Toyota Sequoia Questions & Answers

switch fail --track damage/fail/debris

Best to replace with the same value

Sounds like a Controller Issue with the Climate Control. Seeing that you applied power and it worked, then it is not the Motor.UNLESS you try it on ALL SPEEDS and if it then does not work, you have an Input problem.If it only works on ONE SPEED, then you have a Resister Issue for the Blower

ASK YOUR DEALER

You can get guide from many sites.. i know few error codes/ fault codes, wiring diagrams, schematic diagrams, torque specs, engine info, switches functioning, assemble, disassembly, complete refurbish, repair, installation every single thing is covered within seconds u can get the access and it's totally illustrative complete try reliable-store

I shows that it is located in the engine compartment fuse box.

On the front engine cover near the crankshaft poly,all the best.

Poss defective blower motor, have it tested.

Is the larger of the 2 refrigerant lines getting cold that attach to the rear evaporator core?

Get solution for this online at www.reliable-store.com and get complete guide on whether to repair or not, service it, and how to repair etc

First make sure that the rear wiper is parked all the way down in the receptacle on the door, if the wiper is not down all the way for some reason the window will lock. Next check the motor itself by removing the rear inner panel and the metal plate, apply power from a 12 volt source directly to the motor, unplug it and ground one side and power to the other, the reverse connections if there is no response from the motor replace it, if the motor works this way a common problem is the back door ECU.

Sounds like your door lock cylinders are shot. If you remove your door card, find your lock cylinder and see if you are missing something, or something has come loose. It should turn smoothly and uninhibited.

follow this link as is a common reset procedure How to Turn off Theft System on Cars

No it would not come with a remote.

Most units are inside the console. Some are built with the screen. Being an 03, I would bet it doesn't work anyway.

do a Google image search with the same question I'm sure you will see an image with a list and even an arrow pointing the radio fuse out. A list of fuse numbers is also in your owner's manual but you would know that if you have the owner's manual I'm sure

This communication code (C1203) will be set any time the check engine light comes on. The data link between the two computers becomes interrupted when there is a malfunction in the engine control computer or if the brake warning light is illuminated. The code itself is nothing to be worried about unless it won't clear and this is causing the lights for the VSC system to remain on. If this is the case then there is a problem in the communication line between the VSC computer and the engine control computer. This is extremely unlikely though. Remove the negative battery cable to erase all the memories in the on board systems then see if everything functions normally and this 1203 code disappears

take it to a windscreen shop and have it fixed professionally so that it doesn't leak