My 99 explorer 4.0 sohc had this motor in it I put a 1998 ford ranger 4.0 motor in the explorer but this 4.0 is not the sohc and I can't get it running my thety light is on no power to fuel pump and to the inj how can I fix this
Jump fuel pump relay , connections 87 + 30
1999 ford explorer repair manual pdf
This Service Repair Manual Covers:
Front Matter
General Information
Engine
Suspension
Drive / Axle
Brakes
Transaxle
Steering
Heating, Ventilation, and Air Conditioning
Restraints
Body and Accessories
pdf downloadFactory Workshop Repair ManualService Manuals
Replace engine control module with one from engine doner vehicle ??
Dis you change the engine control module?
SOURCE: Truck Won't Start At All
before replacing the starter get a volt meter and test the voltage coming out of the voltage regulator which the power comes from the battery to the regulator down to the starter also make sure all wires on the starter are clean and what I mean is from rust because I had an f150 that did the same thing
SOURCE: fuel pump on my 1987 ford ranger has no power
There is a Fuel Pump relay. Not sure if Ford has a Relay Box under the Hood though. There are also Fuses that Control some items of the Fuel System. Try the Relays first and see what you have.
SOURCE: 1998 Ford Explorer will not start when hot
Sounds like the choke is getting stuck. It's an electric choke. So, clean it and its linkages. Also, check the vacuum for leaks. With 123K, I'd start with a cleaning.
SOURCE: pulling out the starter motor of ford explorer 1998
Disconnect the battery. Unbolt starter,disconnect wiring. Reinstall wiring and starter. Reconnect battery. You will need a 10mm socket and a 13 mm socket for the bolts and nuts.
SOURCE: fuel pump dose not run 99 ford sable
there is also a trianary switch in the cargo area (trunk) make sure this swith has not poped up just push it down if you hear it click it was probably tripped. If it tripped it may need replaced. These switches were used by Ford for many years to stop the fuel pump from running in the event of a crash. Also have you checked the fuse or the relay these are the areas to start before pulling the tank
356 views
Usually answered in minutes!
×