SOURCE: Imobilising car alarm on Hyundai Getz
it may be worth while changing the battery in the remote as it takes more power to send the frequency to disarm than to illuminate the l.e.d.
SOURCE: hyundai getz
if the speedo still works then it will need a spedo unit if the speedo doesn't work it is either the cable or the gear in the trans to check the cable unthread from trans and attach a drill to the cable innereds spin the drill if the speedo does not move replace the speedo cable
SOURCE: Clutch pedal low near floor, can the clutch be adjusted?
hi the clutch on accent is hydraulic operation so if pedal is very low on disengaging clutch ? you may have a problem with the hydraulics 1st thing to check is fluid level? this is the reservoir that feeds both brakes and clutch but is seperaterated inside if fluid low? top up and bleed the slave cyl however if fluid low indicates a leak ? possibly slave cyl? if no loss of fluid ? then prob may be fault in the master cyl ? check fluid come back with any update please ps if this problem has just occured? check for leaks ?
SOURCE: to change gears, I need to fully press down on my
Hi and welcome to FixYa,
In a manual 2001 Hyundai Accent, the clutch cable could be adjusted. The adjustment point is on the cable 'pad' where it enters the firewall in the engine compartment.
To adjust, the slack or free play must be decreased. This is done by turning the adjusting nut clockwise. Check back by pressing on the clutch pedal to your preference.
Good luck and thank you for using FixYa.
SOURCE: clutch pedal
that clutch system in that vehicle uses a pull type not a push type presure plate, sounds like the release bearing did not engauge into the snap ring in the presure plate there is a certain proceedure for that, you may have to take it back apart.
602 views
Usually answered in minutes!
×